How do I reset xerox C6000? - Phaser Xerox Office Equipment & Supplies

service mode then clear the counters, should have done it before installing the drums.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Replace the fuser

try replacing the fuser it says broken fuser heat wire

Replacing the fuser will fix that. Or if you want to strip it down check the lamps and if they are ok change the thermistor and thermostat. But your better off just replacing the whole unit'

c6000 is a fuser error reset or replace it.

Fusing error have tech look at and reset

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

1. Press the * key and the # XXXXX on the Ricoh copier at the same time and hold for 10 seconds.

2 After 10 seconds or so, the printer will restart itself and will be factory reset.

Fuser error try to reset it otherwise if it didnot work, change fuser unit



I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

Hello sir; Just follow my instruction, I will help you to get rid off the error code; With front door open press10871087 then enter 163 press "start" key, final press " stop/clear " key to get out reset procedure.

Hi

Error C6000 is displayed when your machine fails to reach the correct temparature at a specific time.

This is a Fuser Unit Problem, try to reset it by--

First open top cover then turn on power.
press system menu/counter
arrow down to service
press and hold start, # then enter keys
arrow down to maintenance
press enter
arrow down to Sim 163
press enter
select execute
press enter
turn off power then back on

If the reset doesn't work then get your unit checked for fuser unit and fuser unit heat issues.

Please do rate this solution as FixYa and revert for further assistance.

Thanks
Rylee