Fan # 2 location - Samsung HL-S5087W DLP TV

In the under hood fuse / relay box ! There are three of them COOLFAN/relay 1-2-3 . It's marked on the under side of fuse box lid .
The engine cooling fan system consists of 2 electrical cooling fans and 3 fan relays. The relays are arranged in a series/parallel configuration that allows the powertrain control module (PCM) to operate both fans together at low or high speeds. The cooling fans and fan relays receive battery positive voltage from the underhood fuse block.

you will need the complete model/serial number for proper part#. To locate which fan is problem try watching to see which one is not coming on at start-up.

Step 1:

This cooling fan circuit has 2 cooling fans and 2 cooling fan relays, both cooling fan relays are located in the BJB (battery junction box, underhood fuse box) there is a low speed or main cooling fan relay in cavity location # K-46 and the high speed relay is location # K-47! Also check the main cooling fan power fuse # 2 in the same BJB, The fuse is a MAXI-FUSE (large one) it is blue in color and is rated at 60amps!

Step 2:

Also check the coolent tempature sensor thats what signals the fan to turn on.

Step 3:

Do the fans turn on when you turn the a/c on. if not may have bad fan motor

you need to replace fan #2 , is located next to the lamp is a big fan compared to the other fan you can buy this fans from any electronics place

There are 2 relays for the cooling fans. They are located in the power distribution box located in the engine compartment (see picture below of location). there is a low speed fan relay located in the number 24 position and a high speed fan relay located in the number 32 position (see layout picture below). If your fans are not working at all you may also want to look at the "maxi" fuse in the number 9 position as that gives power to those relays. i hope this helps and good luck.

hello Harley,
Lamp # 1 is lamp fan, Lamp # 2 is DMD board fan.
Lamp # 1 is located behind the lamp.
Pull assy angine out you will fine fan # 2 , clean it or replace it if not rotate properly.
Fans displayed on screen because fans are dirty or air flow not smoothly.
Good luck.

the fan relays are located under the hood in the main fuse panel.look for a black box on the drivers or passengers side fender well. under the cover of the main fuse panel you will see locations of all relays,including the fan relays. thank you,for choosing fixya.com

Hello

Using a stool positioned directly beneath the inoperative fan, grasp 2 opposite sides of the plastic fan cover and pull cover down 2 to 3 inches until wire holding clasps on each side are exposed.

Squeeze the 2 wires on each clasp together until the fan cover is released and set aside fan cover.

Locate fan electrical plug and unplug the connection from the electrical outlet.

Locate the screw securing the fan unit to the ceiling. This is often found directly adjacent the electrical outlet. Some fan models will have 2 securing screws. These will be located on opposite sides of the fan base.

Use flat-head screwdriver to remove securing screw, pull fan out of the fan well and set old fan aside.

Align replacement fan in position to allow electrical plug to be inserted in electrical socket and plug into electrical outlet.

Insert fan into ceiling well and secure by inserting and tightening securing screw(s).

Test fan by turning on wall switch. If fan fails to operate, check to be certain that the plug is fully inserted into the electrical outlet. If fan still does not operate, check circuit breaker and reset if necessary.

Replace fan cover by holding cover in place with 2 wire clasps just below the slots in the fan base. Squeeze the 2 wire ends of each clasp together and insert these into the the slots on opposite sides of the fan base. Once properly inserted, the ends of the wire claps will spring into place.

Push the fan cover up allowing the wire clasps to be fully inserted into the slots on the fan base, at which point the clasps will spring open securing the cover in place.
THANK YOU FOR VISITING FIXYA

There are 2 components that control the fans on these cars. There is a thermo switch in the bottom of the radiator and also a fan control module, which is located below the battery. It has 2 10mm bolts holding it in place and 2 connectors going to it.

Fan relay is located under pass headlight. Remove light assembly, use 2 1/2 " hole saw to drill hole in plastic housing ,3"from back wall, 3'' from left side.This will put you right over relay. Unscrew two bolts,replace. Relay was $40.... dealer wanted$350 to remove front bumper to replace it.