Why does it leak all over floor after last spin cycle?

it could be the felbelt

I do have the exact same problem. Please help. Also, there is a button that shows a spinning sign with an X over it. What does this key option mean?

The last spin is the final Emptying phase. There has to be a leak somewhere in the exiting water route. All tubing and the water pump along with all clamps will need to be checked for integrity.

Poppa

http://www.cdbaby.com/cd/poppamadison

make sure the filter on the pump is not leaking and/or drain pipe not leaking

You may have a pump that's bad. When it goes into spin cycle it assumes the water will be drained within a period of time before it goes into high speed spin. If it goes into high speed spin and the pump hasn't done it's job then you will get a bad mess, flood, water all over.

Rich
Western Appliance Repair
Appliance Repair Meridian

SEAL IS MOST LIKELY LEAKING BETWEEN AGITATOR AND DRUM, SEALS ARE CHEAP AND DEDERGENTS OVER TIME CAN WEAR THEM OUT.

yes, new one more efficient.

if it sounds like a boeing jet, you will need a new seal & bearing kit. This is something a technician would have to do. many "special" spanner wrenches and spring tools required

hI!!! You seem to have a bad transmission or a bad motor they are all expensive to repair..Good luck..

diverter valve is not switching to pump the water out. instead it is resurculating back into the tub.