1E error code - Dishwashers

The "1E" code is an error code that may be displayed on some Samsung refrigerator models. This code indicates that there is a problem with the freezer fan or the freezer fan control board.

If you are getting the 1E code on your refrigerator and the freezer is not freezing properly, there are a few steps you can try to troubleshoot and resolve the issue:

Check the freezer temperature. Make sure that the temperature is set correctly and that the freezer is getting cold enough.

Check the freezer fan. Make sure that the freezer fan is running properly and is not obstructed.

Check the freezer fan control board. The freezer fan control board may be faulty and need to be replaced.

Check the wiring. Make sure that all of the wiring is properly connected and secure.

If you are unable to troubleshoot and resolve the issue on your own, you may need to call a technician for professional assistance. It is recommended to unplug the refrigerator before attempting any repairs to avoid the risk of electric shock.

I'm guessing the error code is 'LE' not 1E.

https://www.hunker.com/13410210/samsung-top-load-washing-machine-error-code-1e

I do not believe that is a 1E I think it's an IE error code which would be water inlet wiring or something like that. Here is the code list, scroll down until you find IE, Daewoo errors start at E2, hope this helps.

http://removeandreplace.com/2015/11/02/daewoo-washing-machine-error-fault-codes/

You need to post more info like a model number

Code 1E: High temperature heating error not normally fixable by owner contact an authorized Samsung service engineer

The Flex zone Temp sensor is the most common issue. check your model number suffix to make sure the part is correct:
http://www.appliancepartspros.com/samsung-temperature-sensor-da47-00095e-ap4136048.html

Best,
Joe

Are you sure it's 1E and not LE error code??  The symptoms you mentioned indicates that it is an LE error code and the motor has an issue.  You will need to call a qualified LG technician to diagnose and resolve the problem.

I posted the same problem on the 15th June and in the meantime I have been playing around with the camera. After holding the camera upside down and gently tapping the back of it, the lens decided to work and retract back into the camera. Not the most technical advice I know but it seemed to work.