Toro zero turn will not turn over

Question edited for clarity, full 'make model (what it is)'.
Question moved from Cars and Trucks category to correct Toro.

In that scenario, the clutch jamming and locking up against something may be a possibility. If the clutch just jams it holds the blades on contact with the drive.

Worn pulleys, badly aligned pulleys, or sticky bearing are much more likely. There is lots of help here as this is a known issue.

https://www.google.com/search?q=Toro+timecutter+breaking+belts

..

Zero turn mower not turning correctly. - YouTube
Zero turn not turning - YouTube

I have found that although they may look similar, with out changing brackets and adding new pulleys they will not interchange. Also decks from the same manufacturer will be different in different years.

ZERO TURN MOWER REPAIR how to replace the pumps and wheel motors
ZERO TURN MOWER REPAIR how to replace the pumps and wheel motors

and this:
Toro Zero Turn Mower Repair Part 1 Toro Zero Turn Mower Repair Part 1

Toro Zero Turn Mower Repair Part 2
Toro Repair Part 2

Anthony

http://www.partstree.com/parts/toro/mowers-zero-turn-lawn-mower/74631-toro-timecutter-ss-5000-zero-turn-mower-sn-314000001-314999999-2014/belt-and-pulley-assembly/

Give this link a try. Once you have the belt diagram, and the right belt, it has to fit.

Better to not jump them can burn the leads up. Pull it out and slow charge it

Use Mobil1 15W-50 synthetic motor oil or equivalent synthetic oil
TORO InfoClick

This page says there's one solution. What is it? Where is ti?

the drive belt pulley probably needs replacing or the belt popped off the pully

i don't think those are replacable i may be wrong but i have never replaced valve guides in a small engine about the only thing that can be done is grounding the valve seats and lap the valves into the new seats..good luck