Water filling slow surging, replaced valve still doing it.

Hi, check to see if there's good water volume coming through the hoses attached to the washing machine. If there is, check to see if the screens inside the water-inlet valve are clean. (The water-inlet valve is the device on the washing machine that the fill hoses are attached to.) If they're clean, you probably have a defective water-inlet valve. If so, you should completely replace the valve.

Have you unplugged it for about 20 minutes yet and tried again?

Hi,
Yes.. the filter is right at the fill valve where the water connects to the dishwasher...

Here is a tip the will elaborate on your problem more, but the bottom line is that you need to replace that fill valve...

Dishwasher Trouble No Water entering Dishwasher
http://www.fixya.com/support/r4021363-dishwasher_trouble_no_water_entering

heatman101

YOU CAN GO TO LOWES IN THE PLUMBING SECTION AND BUY A PRESSURE RELEASE FOR THAT PROBLEM. JUST ASK THE LOWES PLUMBING GUY

The water inlet valve on the back of the unit where the water supply comes in can have a slow leak and will cause ice to buildup and block the fill tube. Disconnect the ice maker line from the valve and watch to see if it has a slow drip. It doesn’t take much to eventually block the fill tube.
The valve can leak because of sediment in the water preventing it from closing or low water pressure.

You can thaw out the fill tube and replace the inlet valves.

check with the plumbing work if that is fine then better take it to the dealer to change the inlet valve. attempting to change by yourself can cause other complications.

Hi, check the exterior and interior hoses for kinks and, obstructions. i would also remove the outer inlet water hoses to check the screens at the water valve. if the hoses and, screens are clear of obstructions, this will lead to a fault water valve assembly. replace this damaged water valve asap in this case.

***. check the water pressure just to be safe. if the water faucets are not open fully, this will cause the slow fill as well. if the pressure is optimal, replace the water valve assembly.

what make?you don't have to change the hoses just check the screens,if the screens are clean,than the water valve must be going bad,put in on cold only,put it on hot only,if one come out slow and the other does not replace the valve($20) mike

Check to see if there's good water volume coming through the hoses attached to the washing machine. If there is, check to see if the screens inside the water-inlet valve are clean. (The water-inlet valve is the device on the washing machine that the fill hoses are attached to.) If they're clean, you probably have a defective water-inlet valve. If so, you should completely replace the valve.

Q - My washer fills slowly with water, what can I do ?
A - Two things could be your problem...
1) - sometimes the screens in the fill valve or inside the ends of the fill hose get clogged up...use a tooth brush to clean them out. Don't forget to shut off the water first before removing the hoses to check for this.
2) - The fill valve itself may not be opening fully = time for a new fill valve.

There is a solenoid control valve on all washing machines, located where the water hoses enter the machine. If you have a rubber mallet, you can whack the machine gently with the mallet. If the problem is resolved, it was just a stuck valve. If not, then you likely will need to replace the whole solenoid valve control. Typically there are controls for each water supply.