I need the assembly diagram for the ice storage caddie model #795.51373.010

Could it be frozen in? If so, u may have bad door seal or ice door seal is not shutting properly.

empty freezer put a pot of boiling water under the ice bin and let it melt it

Jim, i cannot find exploded view of Kenmore...but maybe one of these is similar enough.........

Is there ice in the ice tray? If so the heater is not working to allow the scooper to push the ice out into the tray. If no ice in tray then the fill solenoid is not opening to allow water into the tray. Replace the solenoid.

Hi.

The icemaker AEQ36756907 is sold as a single part. For this reason the manufacturer (LG) does not provide a diagram with the exploded view of the ice-maker assembly (here part). A diagram with the icemaker position in the whole fridge assembly is available in the service manual. Here an example with the same icemaker shown at page 49 in position 600A.

Regards.

Ginko
Other models are similar.

Hello,
This video will walk you through this repair

go to web sight . www.apdepot.com. put in your brand and model # look at the ice maker bucket assm. this will give you a picture af the proper assembly . pt # 12517801 .. **** .

You didn't list your motor size so please pick the applicable diagram:


Accessory serpentine belt routing—4.8L, 5.3L & 6.0L engines


Accessory serpentine belt routing—5.7L engines with A/C


Accessory serpentine belt routing—5.7L engines without A/C


Accessory serpentine belt routing—6.5L Diesel engines


Accessory serpentine belt routing—7.4L engines


Accessory serpentine belt routing—8.1L engines

Prepare the Ice Maker For Cleaning

Step1Lift the power located above the ice maker storage tray.
Step2Unplug the refrigerator.
Step3Allow the refrigerator and to defrost. This will melt any large blocks of ice that have accumulated in the ice maker
.
Clean the Ice Machine

Step1Remove the ice machine storage tray.
Step2Dump any water in the ice machine storage tray.
Step3Wash the ice machine storage tray using warm, soapy water. Rinse and allow to dry completely.
Step4Sanitize the lines of the ice maker. Consult your manufacturer's
directions for steps to do this, because it's not available on all models.

Reassemble the Ice Maker

Step1Replace the ice machine storage tray.
Step2Plug the refrigerator into the outlet to restore power.
Step3Lower the internal power bar located just above the ice machine storage tray. This allows the ice machine to make new ice.

How to Clean an Ice Maker

If you have more questions or need help feel free to let me know, Thanks, Sea Breeze
[email protected]

http://servicepartstec.blogspot.com/

http://appliancepartsse.blogspot.com

I hope you are an electronics major. The ice maker uses the most complicated and heinous electrical theory available. What usuall goes wrong are those hairline contact arms they use. They have assembly tricks only surpassed by the inscrutible oriental puzzle boxes.
For about $150 you can get another.