When I turn on computer, my screen now has a slight blue tinge. How can I get it to go back looking lilke a regular screen? Can Windows 10 to be involve with this?

Some blue screens are caused by Memory issues. First, perform a memory test on your PC to make sure the issue is not hardware related. Many BIOSes contain one that you can run easily from boot up.

If the memory test passes, you may be able to repair windows by pressing f8 repeatedly during boot up and choosing Known Good Configuration.

If you are still having issues after the first two solutions, you may need to use a restore point to restore your computer back to when it was working properly.

There may be some problem with your picture tube else try this that looks like retrace lines. Anyway, you should try to adjust screen pot not focus pot. Make sure you are turning blue screen pot (there are 3 focus pots and 3 screen pots) and do it slowly. If you turn it too much, it will affect your grayscale

Try a weird fix that some people have experienced success with. Remove the battery pack, then hold the power on button down for 10-20 seconds (any extended period of time will not harm your laptop, this appears to only discharge voltage from the system) Reinstall the battery and then turn the laptop back on by holding the power button down for 10-20 seconds. May take 3-4 attempts to get it to boot up. There may be a problem with recently installed programs, the HDD may be faulty or an update hasn't been applied properly due to a compatibility issue. Hopefully the battery removal method will work for you.

Check all connections to the monitor and try it on another computer. If the tinge is gone on another computer, check graphics card on your computer. If the tinge does not go, the screen is failinga nd will need repairing (but most likely replacing)

The power printed circuit board is failing, not
delivering the proper power to the main board and/or the back lamps. One can
have this board repaired inexpensively by a electronic technician. Email me at [email protected]
and we may be able to get your unit working properly again.

IF YOU HAVE A RA 6 CHASSI THE TUBES RUN HOT ANOID CATHOD SHORT IF YOU TAP ON THE NECK OF THE TUBES AND GOES TO SOLID COLOR THEN SHUTS OFF YOU HAVE TO REPLACE THAT TUBE ALL 3 TUBES WILL HAVE THIS PROBLEM

Like all sonys Light engine, Call Encompass Parts Distr. or look them up online 1-800-638-3328 they have 20 of them in stock.

Take the front speaker grille off; it is stiff but will pull off. Take off the access panel underneath; four or five screws. Inside you will find a screen/focus block control assembly. Get a flashlight. Turn up the screen controls SLIGHTLY. for RED, GREEN AND BLUE. The best way to do this is to turn off the color first and make sure you end up with a good black and white pix ( not tinged green, red or blue) then turn the color back up in the menu.

It is fixable depending upon the make and model.

For free sony support go the link choose the produce and chat for free
http://esupport.sony.com/US/perl/support-contacts.pl

Thanks for using fixya. Hope this solution may have helped you.