I have a Motorola AP-5131 Access Point that i can connect through CLI but through GUI nothing.It says wrong password. What can i do?

Yes you can use the two together but remember to set the AP6521 as a Access point.

Max number of clients in a AP5131 is 128

This is the reset username Username : reset Password:
MAC address XX XX XX XX 10 20 = IP address of 169.254.16.32 *10 in Hex = 16 in Dec *20 in Hex = 32 in Dec

Ideally, there shouldn't be any configuration needed. Access points are transparent and only work as a bridge between wireless and wired network so devices should obtain their IP info from your DHCP server not the access point by default.
If you face problems, then there might be a DHCP server in the access point, disable that.

good luck
Othman

go to http:\\ip-adres-of AP5131
wait for login (java must be on your computer; otherwise click on link and install)
enter username : admin
enter password: ????
go to: Network configuraion => Wireless=>Radio configuration=>
and select a chanel.
Make sure when both AP's are to function on one network (+roaming) the channels on both should be different (f.i. choose channel 3 & 6). SSID and key;s should be the same
Make sure to save the changes on the AP.

Click the following link leave feedback if this helped.

Thanks B52Computers

http://support.symbol.com/support/browse.do?WidgetName=BROWSE_PRODUCT&TaxoName=SG_SupportGoals&BROWSE_PRODUCT.isProductTaxonomy=true&BROWSE_PRODUCT.NodeId=SG_AP_5131_1_2&BROWSE_PRODUCT.thisPageUrl=%2Fproduct%2Fproducts.do&id=m4&BROWSE_PRODUCT.TaxoName=SG_SupportGoals&NodeType=leaf&NodeName=AP5131&BROWSE_PRODUCT.NodeType=leaf&NodeId=SG_AP_5131_1_2&AppContext=AC_ProductPage&param_document=sp

exist 2 ways to do it...

first if you now te ip address and the user and password of admin, conect the ap at the ethernet port of you pc and configure it with a ip in the same range that the ap, put the ip direcction in the web browser.

the second way is conect the ap to the serial port and run the hyperterminal if you have windows, maybe you need configure the values of the conecctions.

Just pull the power supply plug out for thirty seconds. It works for me. You are correct I don't ever use the reset button. In fact the techs at Verizon told me to just pull the plug out.
Hope this is what you wanted,
Please leave rating...thank you

1) Must be powered
2) Must use crossover cable
3) Connect to WAN port...

else, download the manual, get a serial cable, and connect to the console port using hyperterminal on 19200,8,none,1,no protocol...