Left front turn signal was not working, and i replaced it with a new bulb but it did'nt work...please help .. ty

Replace the bulb

it's the grounds if they're both flashing fast it's definitely grounds take a test light and see if its got power goes through the test light grounded to the frame and if the light comes on then it's definitely your grounds

Hi

Did you check the fuses for the turn lights? Do the
parking lights work? If the parking lights work then you probably have a
problem either in the switch or in turn signal module thing.
The burned out bulb is what might be causing it not to blink... if one bulb is burned out you gotta replace it, make no difference if front or back,the left blinker will not work if the left front or rear bulb is bad.
same with the right side. if the front right or rear right turn signal
light is burned out it will not work.....get replacing the bulbs.Hope this solves your problem.Please rate me if my solution helped you.

Regards,
bonefirediv.

Hey I literally just today had the same problem, put a new bulb in the light was on but did not blink!!!! SUPER EASY SOLUTION, you simply have the bulb in too far. I gently pulled mine out a tiny bit and it started working fine... guarantee that's all that's happening to you!!!

are you sure that you put the right bulb in? Some of these bulbs look very similar, (like a 3057 and 3157 or 3156) but they are different. A customer came in with this problem and the problem was that they put a bulb with a single filament in when it was supposed to have a dual filament. the bulbs looked the same and they just grabbed them off the shelf instead of asking the parts guy what their vehicle called for.

Your right rear turn signal bulb is blown.Replace the bulb and the fast blinking will stop.

sounds like you have a bad flasher which is usually located near the steering column under the dash. check for ground on front left bulb. may have to replace light socket if ground is good.please leave comment.

check the front right bulb

we found the flasher curcuit had no power to the hot prong. So my friend wired the flashers hot prong into the radios fuse curcuit to get power to it and put a separate 10amp fuse on the new lead.

There is probably something shorting the front turn signal wires; the car is supposed to turn the signal light circut on and leave it on if it detects a burned out light bulb. The flashers, however, are supposed to work normally no matter what happens.
Hope this helps!