How do I take the gearbox out of my krnwood kmix

Question edited for clarity.
Question moved from Cars and Trucks to model category.

The OP, George supplies the answer.

Update solved: problem was the tiny speed control sensor mounted above on the motor with three cables.

Help in the link including from Kenwood themselves.

It is likely to be the selector, the control board or the motor. Take it in for Dealer Service.

https://www.google.com/search?q=Kenwood+kmix+doesn%27t+start

..

If you do not know what you are doing it is better to throw it away and get a new one. You could get electrocuted if you try yourself. Probably cost more than a new one to get someone to repair it.

Hi Carol , I had the same problem. You should open the main cover, then, remove the 3 screws (see picture), and remove the nickel plated ring, then, take out one screw from the bottom (see picture), then open 4 screws that holds the gear box from the top .

good luck.
Pini

The owner's manual is here: http://www.kenwoodworld.com/Global/Instruction-Manuals/kMix-by-Kenwood/kMix-Kitchen-Machines/KMX80/18499%20KMX50%20A5%20multi.pdf I could not find a service manual.

yes the dough hook is a firm fit on those

Instruction Book KMX50, KMX59 English - Kenwood

www.kenwoodworld.com/.../Instruction-Manuals/kMix.../kMix.../18362iss2%20KMX..

Hi, it sounds like a broken gear.

Send me your email

Here's how to fix the stuck implement problem:

The implements each have adjustable heights. to adjust the height you need to loosen the bolt at the top with a 14mm spanner. If the bolt was loose when it was being used then it can get too short and not leave enough clearance between the bolt and the machine in order to push up and turn to release the implement. If this happens take the open ended spanner, grasp the implement and rotate the spanner clockwise (when looking up at the machine from below. Once the nut is loose rotate the implement until there is enough clearance to remove it normally.