Intuitive eco Iw811 Rinse 1 no water coming thru!

IW Intuitive Eco.
Water valves have a rubber diaphragm that wares out
after some time,
So yes you are right water valves need replacing.

Possible Cause Solution The power switch is not turned on at the wall. Unplug the machine from the wall. Wait 60 seconds, plug back in and turn the power back on again. The household power supply is at fault. Try plugging another electrical appliance into the power slot.

Hi Maree just read your posting.Sounds like a fault I had on an intuitive washing machine the other day.To repair that machine I 1st changed the hot water valve then eventually had to change the control module.Is your machine the 'Intuitive model'?Is the machine beeping and showing an error code in the led display? Please reply with additional information and I am sure I can help.Looking forward to your reply.

why life so unfair ?

intuitive ECO Model IW811 display error code 49...any one can help me

Hi just read your posting.Now just a couple of questions.1st where is the machine draining the water to?Is it into the laundry sink or to another place?Have you removed the clothes from the machine?Have you tried putting a bucket or two of water manually into the bowl and put it to a spin cycle to drain the water out? Please reply with additional information and I can help you further.

the programer has given up the gost on you only thing you can do is try to replace it,,,

check to make sure you have both the hot and cold water lines connected and the water is turned on. sometimes the hot or cold line will clog up and it will not fill up during the rinse cycle. the humming sound may be the water valve coming on but no water is coming thru.

if you have a warm rinse set it to that to see if this is the problem.
you can clean the screens on the water valve by taking the water inlet hoses off the machine and you can look at the screens onside.
if not it may be a timer problem.

Check your exit hose spigot, it may be clogged. This is if your filter is all clean. There should be air for passage in the standpipe behind. Your hose should not fit airtight into the standpipe and neither too deep into it. Snaking out your standpipe would be good too.

Rate me pl.....if helped.

Does the water fill to the correct level ?