I have a thin wire trapped in my drum making a terrible noise is there anyway i can get it out.

http://www.appliancepartspros.com/frigidaire-shock-absorber-kit-5304485917-ap5590192.html

https://www.repairclinic.com/RepairHelp/Dryer-Repair-Help

The drum rollers or idler pulley/belt would be suspect. The link above will help on all makes and models.

I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

You could try a very thin pair of twezers, or a very thin magnetic pick up tool,you might be luck.. if not the only other way is to remove the ruber door seal to get acces to the inside of the drum.

This can be a symptom of drum bearing wear. A quick check for wear is to see if the inner drum moves up and down relative to the fixed outer drum. It should only move a minute amount. If it moves more than a milli metre or two, it is probably worn bearings. You can obtain bearing kits for most makes. If it is making unusual noises while washing too, check there is not a wire or similar object trapped half way into one of the drum holes. A high pitched whine is sometimes caused by the motor bearings (but most brush/commutator motors whine a bit anyway on higher speeds, it is normal). Oil sparingly so as not to contaminate the carbon brushes.

take the top cover off the unit(after UNPLUGGING unit of course)screw location varies on units,some you need to remove front cover first to access screws for top

depends on what make of washing machine it is best way is to locate where the element is either in the back of machine or the front. remove element normally the wire gets caught around the element

Remove the drum.
Inspect the drum seal,rear rollers,tension roller,front drum glides.
It could be any one of these bad or a combination of theses.

well, i can get into the machine, not aproblem.. is the coin perhaps trapped inside one or more of the innerr drum viens perhaps??? anyway, ifyou removet he2 screws securing the door, and the 2 screws opposite the hinge, the front "u" shaped front panel will tilt off fowards.. from there theres a few 5/16 screws holding the main top assy to the froma of machine, you can remove them and tilt the top back, giving you acess to the outer drum assembly( and you can removethe drum viens and retreive te hoffending "coins" in htat fasion.. hope this helps.. TURN OFF POWER TO UNIT<< LIVE WIRES!!!!!!!

Try to see if there is a large rubber sleeve underneath that you can remove. It will probably be fastened with a clamp. Make very sure that you get it tightened afterwards, or it may leak.

probable that the bearings have collapsed. remove back panel.undo wiring to heater and stats and make a note of where it goes. remove back plate of the tub assemby held by a clamp right round. drum andback plate then come out complete. take off pulley and put back bolt in shaft. tap bolt and you should be able to knock drum from backplate. you can then check bearings. you will need to replace bearings, lip seal and backplate seal.parts are not too expensive. check also condition of journal lip seal runs on. this must be in good condition.