It shows a f1 code - Washing Machines

contact your local dealer about it we have no code list for that brand

F1 FAULT, HAVE YOU WIRED IT FOR THE CODE, F1 IS SAYING TO CHECK THE CODES, NEED TO BRIDGE THE WHITE 4 HOLE CONNECTOR USUALLY UNDER SEAT

For error code f1 on washing machine click the link below :---
http://repairhelpcenter.blogspot.com/2012/01/code-f1-on-cabrio-washer.html

----------Also one more help link:---http://technoanswers.blogspot.com/2012/01/cabrio-washer-shows-code-f1.html
-----------Thanks.

Hello Charlie,

The F1 error code means that the computer thinks a button on the touchpad is stuck. Sometimes this can be resolved by making sure the touchpad connector fits tight into the control board. The F1 code can be cleared by pushing CANCEL/OFF. If it returns the touchpad needs to be replaced

GENE

1. form f1 = new form1()
2. f1.hide();
3. form2 f2 = new form2()
4. f2.show();

Test Code :
Form1

private void button1_Click(object sender, EventArgs e)
{
Form2 _f = new Form2();
_f.Show();
this.Hide();
}
---------------------------
Form2

private void logoutToolStripMenuItem1_Click(object sender, EventArgs e)
{
Form1 f1 = new Form1();
f1.ShowDialog();
}

F1 - E1 EEPROM checksum error 1. Disconnect power for at least 30 seconds.
2. Re-apply power and observe for at least one minute.
3. If code re-appears, replace control board (also called ERC or clock).

Note: Applies to all F1-E... codes except F1-E3.

Hi bobctsai,

F1 error code description is a defective touch pad or clock (ERC). To resolve this error, replace touch pad or clock (ERC). Touch pad is a more common problem.

Hope it helps.

Thank you for using FixYa.

with an f1 code most likely youd have to replace the control board f1 is also know as the code of death 99% of the time it is the main control board

You can hold down the start key when the F1 is displayed it will show a sub code. The service manual for that model shows only one F1 code which is an F1-06. That is a shifter motor trouble. That is the section after the exit that offsets the copies.

You can reset the code with the instructions below. If the error recurrs then chech the exit section shidter for proper movement. You may require an on site technician to remedy this issue.

To reset the error code:
Hit <clear> <interrupt> <0> <interrupt>
14 <start>

This code is in responce to a fault/failure in the lower keypad assembly. It is possible the keypad was bumped.

Maytag Gemini fault codes.
Fault code Suspect area Fault code Suspect area
F0 - 0 None
F1 - 1 Runaway cook upper oven
F1 - 2 Runaway cook lower oven
F1 - 3 Runaway clean upper oven
F1 - 4 Runaway clean lower oven
F1 - 5 Keypad cancel upper
F1 - 6 Keypad cancel lower
F1 - 7 Keypad disconnected
F1 - 8 Keypad shorted
F1 - 9 Slave