SOURCE: The right hand side indicator
Hi if when you put the hazzard lights on all the indicators work then this suggests the problem is with the indicator switch, you may need to get it replaced, it could be that it has got corroded due to rain or damp getting in, if the hazzords are working ok then you know the fuse and bulbs are good so all thats left that could be wrong is the switch that works the indicators.
this will need removing and replacing to solve your problem
SOURCE: pride vicyory viper mobility scooter. no power no
about the only thing I can suggest is to make sure you have power out of the batteries going to the system. If you have a charger port located on the tiller take a digital volt meter and set it to 200 vdc and plug the leads into the two outter holes of the charger port with a full charge you should read 25-27 volts. If you don't have a reading at the port then there is a problem with the power getting to the tiller. It could be a bad cable Pride is notorious for developing problems in the cable going to the tiller. I would suggest you find a repair service to check the scooter for you. Maybe your provider (where you got the scooter) has a tech that can check it for you. I'm sorry I can't give you a definite answer but there are so many things that can affect a scooter: bad throttle, bad speed pot , bad cable, bad connections, bad batteries that its difficult to give you one answer that will fix your probelm Hope this helps you
SOURCE: on my icon 4 scooter
Hello Harold,
Please visit the link provided below :
http://site.a2bscooters.com/royaleusermanual.pdf
http://www.evrider.com/manuals/royale-3-and-4-user-manual.pdf
SOURCE: the scooter works except horn
Hello
For the horn most scooters,the horn has voltage to it, just needs a ground to make it sound. Check the grounds and the terminals at the horn(s). Vibration may have broken the wire internally or at the terminals.
For the light pull the front panel off and make sure that the swtich wires are connected. also pull the side plastcis and make sure that all the wires coming up from the motor thru that rubber grommet are also connected.
268 views
Usually answered in minutes!
×