Dc1414f charger does not work anymore how to get the charger back charging again

Use a mobilephone charger, not a cable for PC; then update the firmware.

Unable to turn on my plantronics 210 explorer bluetooth .therefore no light is showing in it. charger is fully charged

Sounds to me like the device is faulty and there is nothing you can do about it. You will need to return it to the place you got it from. I deal with this sort of thing on a daily basis at work and that's what we usually do with phones with similar problems.

You stated you have a 12V Cordless Drill with PA14 batteries. The PA14 battery is 14.4V. The battery may fit in your tool and might work for a while but the motor isn't made for that battery. The way to check the batteries is to try them in another charger, any 14.4V to 18V pod/stick charger will work. The way to check the charger is to try another battery, any good 7.2v to 14.4V pod/stick battery will work. Unless the charger got wet or extremely hot the problem is usually the battery. Just check to make your tool and battery voltage is compatable.

Hi, as per your information your camera 2 years old but not used much. You buy a new battery 1st time when you charged you see the gree light. But camera not working. When you try to charge the battery again you seen the red light. Its mean your charger have a problem. So what you do now? Ok try these.
Remove the power connection of the charger. then fixed the battery there slowly & properly. After that plug on the charger again. If the same thing happens then unplug the charger & plug in in different point. Then see what showing. If again red light then wait 1 hours and waiting for green signal. If there is no green signal showing then visit a service center with your charger. Tell them your problem. They will fixed the charger for you. Don't worry your camera is ok.
Your new battery or your charger one of then damaged. Thanks & waiting for your feedback.

try disconnecting the battery and try to charge it again. if this does not work try charging a good battery if this still happends you have a faulty charger.

I have an 890 also. I've found that the remote doesn't always charge when it the charger. I have to put a rubber band around it and make sure it shows that the the battery symbol on the display is showing that it charging. Or the battery isn't taking a charge anymore and I'd try to replace it. Doesn't really hold a charge very long either.

I took the camera to the representative and we started various tests such as:
Tried My battery in OTHER camera .... not working
Tried OTHER battery in MY camera .... works
Tried charging MY battery in OTHER Camera .... works
Tried MY battery in MY camera and charged .... worked
Bottom end is that my charger is not working although it heats when "charging".

Now i will look at the pins in the charger to see if they are working or not.

Whatever the case .... getting a new charger.

umm i have jazz camera and i didnt have a charger **** i bout a motorola house cahrger and it charged my camera.

You need a new battery. That battery goes dead maybe its a factory defect its very rare this to happen but try to contact the Company to ask if you have a warranty for this unit. One more thing make sure that your charger is functioning.