SOURCE: Ld error on Maytag Bravo. How to remove items stuck under tub?
if you can see the socks you may be able to remove by making a wire hook with an old coat hanger or something similar if you are able to undo the hose coming out of your bowl to the water pump you may be able to also fish out the coins if you are lucky but the best way is to dismantle bowl let me know how you went
SOURCE: Hi there, My Westinghouse washing machine
Hi just read your posting.Now are the springs at the bottom end of the suspension rods inside a tube with a rubber insert at the end of the rod?If this is correct then it will be the same as most top suspended washing machines.We call these tubes dampeners and they stop the spring from reacting too fast therefore keeping the inner bowl steady.Now try this.Take the weight off each rod one by one so you expose the spring the put some bearing grease around the rubber insert.Be generous with the grease and do this to each rod.This will help the rods react properly to the shifting weight of the bowl and help seal any wearing of the rubber.Make sure to replace the plastic cap and please reply if you require further help.Good luck.
SOURCE: maytag bravo quiet series 300: Stopped at spin:
We have a Maytag Bravo Quiet Series 300 washing machine, the door latch is broken. I have the replacement part ( the locking mechanism) but I need can not figure out how to get the top of the washer to flip up to give me access to top front of the machine to remove the old part and replace it with the new.
How do I flip back the top (not the door) of this machine?
John
SOURCE: how to get the clothes out of my maytag bravo that
Hello, welcome to FixYa
To address your question "how to get the clothes out of my maytag bravo that is in between the tub" you should do as follows...
**First unplug the washer... safety first**
1) the top needs to be lifted, this is best done with a puddy knife or something similar to depress the clips on both sides, i.e. (these tops are quiet heavy and the lid has heavy springs so be careful...leave the top in the "up" position until you can rest the entire top against a wall or something to allow you to work un-impeded as show below as well )
Lean it back if possible...watch that lid again, those springs are heavy duty.
2) remove the re-circulation hose clamp for the top deflector/splash guard...and remove the guard via the clips around the tub.
Pull's off,
3) remove the "agitator" assembly (we'll call it that anyway)...first the cap, then the 7/16" bolt, pull straight up (you may need to wiggle it back and forth until it lets loose )
7/16' bolt,
4) once removed you'll see the outer basket hub, you do not even need to remove this via the philips head screws...sometimes it helps to loosen it, but don't take it off completely. Then the entire assembly will lift out ( again you may need to wiggle it around )
That should gain you access between the tubs. Also I'd suggest you check small plastic cover over the pump outlet/sump area. It's a good idea to remove it and check around or clean out since you're in there.
That should give you a pretty good start or in fact all you need to clear up your problem. Let me know how you make out and we can go forward from there if necessary. Good luck.
I'll be watching for your post on progress/completion.
Regards,
Macmarkus :)
226 views
Usually answered in minutes!
×