Its not what is the max length you can use on this machine , as this one if it operates at 220 volt 50hz only draws a little over 8 amps , but how large the circuit supplying is fused for , as 200 ft of 16 ga power cord would provide a voltage drop to only 207 volts (vs 220 volts) this would now make your tool draw a little less than 9amps plus your tool is not operating at its full voltage/speed and it heats up more and does less work so will take longer to do same work
any cord length that produces a total current load to near or over 15 amps total load is gonna produce problems for both tool and operator
131 views
Usually answered in minutes!
×