Asko W600 extra rinse button not working

Your Service Manual is here:

Asko W600 Service Manual

Try pages 20 ~ 22

Anthony

check whether something is blocking the cycle.

Try to press the start/stop button for at least 3 seconds. This should reset the started cycle, and you can make a new choice. If this dont help, it could be a faulty control board

try this
turn the machine on at the wall select what you want then press the start button
it is possible that you are trying to change the program after it is started and that is causing conflict

Hi

First make sure that nothing is blocking the drain pump assembly located inside the bottom of the unit, after this test the door lock-switch assembly. If the door lock-switch is also fine then the control board should be replaced. Hope this helps...please post back for further assistance.

Daniel

Hi just read your posting.Now the place to buy all spare parts for ASKO washing machines is in MELBOURNE. Asko has their factory in Moorabbin.If you ring up directory assistance and ask for Asko"s phone number they will provide it.Then you can buy the motor over the phone and it will take a couple of days for delivery.Unfortunately I do not have the phone number off hand.By the way why are you replacing the motor,maybe I could help with the problem.Please reply to let me know how you got on.Looking forward to your reply.

hi yes you need to replace the inlet valve you have dirt in it,remove the top panel you will see the triple valve.its very easy to replace,

does it not have a manual door release pull next to the filter

Hi
download the manual as pdf and print it .

go to :
http://safemanuals.com/user-guide-instructions-owner-manual/ASKO/W600-_E

Had a repair man here for the same issue. Learned two things:

1. Too much detergent causes 'soap lock.' The electronics will get confused when there's too many suds left after a rinse and shut the spin cycle down. That's why re-running the entire cycle without more detergent solves the problem. Use less detergent.

2. There is a way to manually get the spin cycle to run using diagnostics codes. Here's what my guy did:

a. Washer selection knob in OFF position.
b. Hold the 'Spin Selection' and 'Delay Start' buttons down at the same time.
c. While holding those two buttons, turn the Washing selector knob to Permanent Press-Cold.
d. Keep the buttons held down until the LCD control panel reads 'P:01'
d. Release buttons.
e. Use the 'Spin Selection' button to cycle thru the codes. Stop when it reads 'P:04' which is the spin cycle.
f. Press 'Start/Pause' button to begin the spin cycle.

I don't know what the other codes do but this should save you from having to run the entire wash cycle.

Hope that helps! Tim