Where can I find a foot pedal for a White sewing machine Model 967 or one that is compatable?

SOURCE: foot pedal assembly for White sewing machine

You only need to replace the cord if it has been damaged. It will cost less if you just take the machine , cord and control to a local technician and have him just replace the foot control. Let him test it first. A generic foot control should cost less than $30.
sewman7

Douglas Plant

• 222 Answers
• Posted on Sep 01, 2010

SOURCE: i have a model 1620 jcpenny sewing machine.all

You need to purchase a foot control with a M&L block and that will fix you up. The only place that will carry those is a sewing machine store.

SOURCE: need power cord and or

try sewingpartsonline.com

SOURCE: Euro-pro model 4c-316B I need to buy the double

here are some website that carry euro-pro items
mastersewusa.com
sew4less.com
sewingmachinestitch.com
sewingcenter.us
euro-pro.sewingmachine1.us

SOURCE: I have a white quilter's sewing machine, model

Hi, follow the instruction below to troubleshoot the foot pedal

• Unplug the machine plug and wall plug on the sewing machine.
• Check the power cord for cracks, burns, or faulty contacts as this could be a possible reason for the foot control not working.
• Open the foot control by using a knife or flat surface tool, such as a flathead screwdriver, to pry open the corner of the foot control.
• Check the wires to see if they are disconnected; this can happen if the foot control drops to the ground. To check wires, remove the circuit board using a flat knife. Inspect the wires inside the foot control. You will see some wires that are soldered together. Check to see if there are any broken wires, as this could be the problem. If the wire is broken, clean the area to remove any debris or dirt. Remove a small amount of the insulation before soldering. Solder wires together.
• When you are done, reassemble the foot control and make sure it's working again.