Pump won't come on unless i press the reset button

Hello,

"Reset the lamp counter
i. Press and hold Exit on the projector
for 3 seconds to display the total used
lamp time.
ii. Press Menu on the projector or on
the remote control to access the lamp
hour timer. An adjustment message
will appear.
iii. Press or to reset lamp hours
and press EXIT to leave."

Most Netgear routers have a recessed button on the back or bottom panel, marked "Reset" or "Restore Factory Settings". Because the button is recessed, you will require a thin tool to press it. Most people use a straightened paperclip.

1. Power up the router, and wait for it to complete booting up, typically about one minute.
2. Press the Reset or Restore Factory Settings button until the test or power led starts blinking. This takes about 20 seconds. Release the button.
3. Wait for the router to reboot.
4. Log in with the default password. If the reset was not successful, try these additional steps AFTER the router has finished rebooting.
   
5. Unplug the router's power.
6. Press and hold the Reset button. While the button is held down, reconnect router's power.
7. Continue to hold the reset button for 20 seconds after reconnecting the power.
8. Wait for the router to reboot.
9. Log in with the default password.

Reset your Linksys router so you won't need any password to lo into it. To reset it, use a small pointed object to press and hold the reset button for about 10 seconds.

Turn off ignition. Press and hold the trip reset button, then turn the ignition on (don't start the engine), within 5 sec the SIA status will be displayed. Release the reset button. Press and hold the trip reset button for 5 sec, "rst" will be displayed. Release and re-press trip reset button.

The new status should be displayed.

look for 2 things. 1. the GFCI button on the plug, you may have to press the 'reset' button to turn it on. 2. there may be a reset button on the motor or the unit somewhere this will usually be round, and often red, but maybe black also. hope this helps

Hello

When operating, errors happen. Turn off the device.

(To turn off, press and hold the power button on the front
of the device for 10 seconds.)

After turning off, press the Open button and remove the
disc from the device
If needed reset the device to its factory settings after the disc is ejected. To reset it to factory settings:

Press the [UP] and [DOWN] buttons on

your DVD recorder simultaneously

when the power is on. All settings

including the password will revert to

the factory settings. Do not use this

unless absolutely necessary.

(Note that this function is possible only
when no disc is inserted.)
ok.

press the reset button on the power brick, if that doesn't work your power button may be broken. Unless..... RROD!!! Then just send it on its way to Microsoft for a free replacement.

what year?? I'll guess. press the < or > button until oil life appears. press and hold the select/reset button. 10 seconds. it will ask to confirm, press the button again. done. Dont reset unless you really have done the required maint. its really vital to keep your car running as good as it should.