How do I change the batteries in the Zhu zhu pets?

What make , model an year vehicle . Engine size too . Battery voltage to the heavy wire on the back of the alternator ? Could be computer controlled . How many wires at the connector that plug's into the alternator ?

May need a new one then if u already changed battery out

I moo too, but thats OK , I am a cow

clean contact surfaces of your battery clamps

change the hamster!!!!just joking..change the fuel filter first then see about a tuneup..which includes all new filters..

I just figured out how to change the battery in the Advanced (keyless) fob for my 2010 Mazda CX9. You just need to take out the physical key, and use a small flat-head screwdriver to pop off the back cover. Then there is a black battery cover with an o-ring that just pulls up to reveal the CR-2032 Battery. Here are some pictures to explain better:

Hello: You need to change battery. On the end where it attaches to your key ring you will see a slot. Take a penny insert into the slot it that will cause the two halves to split, the battery is inside. Before you remove the battery note the position it is in when installed. on the battery on one side there is a + (plus) sign. On the other side is a - minus sign. The number (size) of the battery is also stamped on the battery. Replace with the same size battery, it does not have to be by the same manufacturer. When removing and installing new battery be very careful not to touch any of the electronics or damage the parts that hold the battery. make sure all is lined up snap back together and you are good to go.

Thay did not put your tire sensor back in if you had any.

blower motor resistor

Some one just came NTB when i was in there and couldnt find the battery on hers it was behind the seat she said, Look up year make model and get the correct size for the car fit back in take the old one match up for correct size crank amps and some connect on the sides of the battery