Hello i have cybrepower inverter model no CPS1200EILCD on inverter mode giving long beep and no out put

Congratulations, your air conditioner has hit 720 hours of use. In an attempt to push people to keep these things extra clean the built-in this annoying feature that spits out an alarm every 720 hours of operation.

Let's reset it and hope that she lasts long enough to give you this error many times to come. :-)

Two ways to get it done:

1) Unplug the machine. Hold down the power button while you plug the machine in and wait for a beep about 5 seconds long. Let go of the power button. Unplug the machine. Plug it back in.

2) Unplug the machine. Hold down the mode button while plugging the machine back in and waiting for a beep of about 3 seconds duration. Let go of the mode button. The machine will start. Turn the machine off by pressing the power button. Resume trying to use the machine normally.

If these don't work, the "demand to clean filter" timer is broken and you will need to buy parts to repair the machine.

You either had it hooked up backwards or there was not enough charge on the battery you hooked too.

check batry voltage or 2nd problem in realay and capicitors or
3rd ic before that disconnect output line

Seek a refrigeration mechanic. With out looking at the unit it is to pin point problem.
More than likely a PC board issue on the indoor or outdoor unit. Does your remote control give you an error code. If possible look at the users manual on how to get the remote to give you the error code.

Hello I was in the same problem the last 5 hours causea icant find my owner manual, i put a new battery on my "oldie" but great watch and pusshin and seting i got it....

You have to put in "alarm mode", remember you have to push BOTON MODE. Then you will be at "stand by mode", "data bank(phone) mode", "world time mode", "alarm mode" "chrono mode", and set (analog watch) mode"

then you are in "alarm mode" then push "REV and FWD BOTONS" at the same time, one time, or two times or three times, until the "beep icon and bell icon" are in ON mode

Good look

sareg@hot....

Hello Two options to try: a) Press the Clock / Timer button 3 times b) Unplug, wait a few seconds, then re-plug to power up with the factory settings. You will need to reset your clock and any favourite settings.
This should work with all Panasonic Microwave models.
Good luck

Try booting your computer in safe mode and check the time on computer, if its different than the current time, try changing CMOS battery.

hello our pool chlorinator keeps comming up low salt 91 no matter how much salt we put in this is frustrating why is this happening ,,,please help

got a cobra cpi 480 inverter it keeps beeping everything runs but produces no power

Try setting to the native resolution of 1440 x 900.