Samsung LN32A330 32 in. LCD TV Logo

Related Topics:

F
Frank Small Posted on Dec 28, 2014
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

TV takes 10 minutes to settle down cracking sqeaking hazy

I would not no what to try and do

1 Answer

mika

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

  • Samsung Master 469 Answers
  • Posted on Nov 21, 2016
mika
Samsung Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

Joined: Nov 16, 2016
Answers
469
Questions
0
Helped
225008
Points
2864

AmanStino Ultra Slim Lightweight Smart-shell Stand Cover with Auto Wake/Sleep for Apple iPad Pro 12.9 IN - Black

  • Designed specifically for iPad Pro 12.9 inches iOS 10 Tablet. Easy access to all features and controls.
  • Ultra slim and lightweight hard back design adds minimal bulk while protecting your precious device.
  • Premium PU leather exterior and microfiber interior.
  • No bezels around the screen allowing for unobstructed gesture swipes.
  • Easy clip-on application. Easy clip-on application. Automatically wakes or puts your device to sleep when the lid is opened and closed.
AmanStino Ultra Slim Lightweight Smart shell Stand Cover with Auto Wake...

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Hazy crt tv picture for the first 15 minutes after turn on.

yes,, while heating up,, some transisters are failing.. have to check the circuit board,,
0helpful
3answers

After 45 min, Screen gets hazy and with green artifacts on the right of objects

These are two variable resistors has some glue on it for protection, means NOT to adjust it as already adjusted in factory.

d620d4d.jpg

now regarding pulling two wires, one thick wire can be pulled ( not in all cases) as shown in below picture. Push it and rotate it. If this not works, don't pull it force ly. just go to other end of this wire and try this method.

ef6c9da.jpg

LOL, my drawing isn't good :P
0helpful
1answer

My Tv doesn't not want to turn back on

my tv will not reset . the green light just keeps blinking
0helpful
1answer

All of a sudden this TV has a problem of loosing voltage to the CRT and the screen suddenly goes black. After about 10 minutes the picture comes back. If you leave the set on for quite a while it seems...

You will have to tip the chassis up side down and look over most of the chassis close to the High Voltage Transformer (IFT) look for cold joints around there first, then locate the Vertical IC and look very closely at those pins, they usually have hair line stress ring cracks around them. If youv'e never done this type of work before I would take it in to a service co. It's not a major repair.
0helpful
1answer

Calapsed picture frame

Hi there,

This can only be a bad soldered on the video module, its better to check for any bad soldered and for any fault on the resistor on the video output module.

Hope this initial info / idea helps.

Please Accept my solution if I solved the issue.

Regards,
micro
0helpful
1answer

I have a terrible sqeaking noise coming front of my 1999 crown vi

Sounds like the front shocks/struts are too weak to support the vehicle. Stand at drivers front of vehicle and push down very hard watch as vehicle rebounds and bounces until it settles, then try the same on passenger side. Good shocks/struts allow a bounce or so, but will appear firm not loose.keep me posted to your results.
0helpful
1answer

Wavy picture for Toshiba Model 50H12 Rear projection TV

In general, these problems are usually caused by leaky output filter capacitors in either the low voltage power supply or, depending upon the type of waviness you're attempting to describe, it could be in the vertical deflection circuits (either the vertical oscillator or vertical amplifier). I would estimate cost to repair from $200 to $350 dollars, depending on how long it takes to find the problem. It most likely though is a component issue in the circuitry.
0helpful
1answer

Tv Flashes

key2life316,
Your TV has a bad picture tube = no reasonable repair possible......time to go shopping!....................T.

Guest,
Your TV has a bad pix tube + a blown power supply!!
Time to move on ........T.
0helpful
4answers

Toshiba model 57H81

If you have zagged lines there are 10 small surface mounted capacitors you will need to change on the HYper Board. This is not an easy repair so alot of folks simply replace the hyper board. You will need a service manual to take this set apart and to get the proper part number. If you have no TV repair experience or do not know how to solder, as the hyper board has sheild arounfd it, you should play it safe and call out a pro to assist you in this repair. Good Luck
Not finding what you are looking for?

95 views

Ask a Question

Usually answered in minutes!

Top Samsung Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Samsung Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...