Have a Roland Versacam VS-300i. Started a job and all 10 prints have printed and 6 of the prints has cut on the cut line, but then the machine stopped and the indication panel says "Now processing" an

This is a Professional quality printer. Contact Roland Support direct.

https://www.rolanddga.com/support/products/print-printcut/soljet-pro-iii-xj-540-54-eco-solvent-inkjet-printer

..

Try unplugging it for 10 minutes to reset it.

also clear out all print jobs on the computer and then try again and let me know what the situation is after following the two directions I gave.

thanks

Printing half a page with an Inkjet machine is not normally a computer issue. So windows 10 would not normally have any effect on the printing for a printer that has been accepted by the Windows 10 Operating System. If there was an issue in the software it would be printing gibberish or not printing at all.

Printing half a page is quite possably something stuck in the printer stopping the ink from getting to that half a page if it is printing down once side but not the other.
Printing half a page being that the top half is printed but not the bottom half (Or the other way around) it could be an air bubble in the feed line which can be cleared with a printhead clean or two.
Printing half a line rather than a full line such as the top half of each letter is clear but the bottom half of each letter is not visable is a blocked printhead. A couple of printhead cleans can also fix this.
Also check to see if the printer is not confused and actually has empty cartridges even if the printer thinks they are full. Brother printers can easily get confused about ink levels. If the cartridges are actually empty, replace them and away it should go again.

Hope that helps

www.rolanddga.com/owners/support

support roland((( or try another OS and drivers

IF I CAN REMEMBWE YOU CAN DOWNLOAD IT FROM THE ROLAND SITE

To delete ALL print jobs:
Turn OFF. Let it power down all the way, wait 10 seconds.
Hold Energy Saver + 6 + Stop.
Turn ON.
Release buttons after Xerox logo appears.

This happens occasionally with myself if I am printing a large number of labels which is taking a while and decide to cut off some already printed labels from a previous job off from the roll before the current label job has finished. It then feeds the roll back past the edge sensor on the front, gets confused and flashes the lights. I don't unfortunately know how or if the printer can be restarted from this point. If I do i'll post here or if you manage to fix it please let me know. It has something to do with me cutting the roll and the roll passing the front edge sensor.

try to clean the print heads of the ink cartridges. you can do it in the HP solution center. you can run it through all 3 tests so you make sure its clean. if it doesnt work after that, your ink cartidge level might be off, because i hear they never work half the time anyways. i would buy new ink if the cleaning the heads does not work. good luck!

look on www.rolanddg.co.uk and they might just help. i have just got a pc60 and the test print/cut is'nt working so i'm not a happy bunney. Andy @ YesIDoOwnTheRoad.com