- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There are set by you to feet, metres, 'F or 'C, knots, kph, or mph.From a bit more reading, depth is Feet, distance is Nautical Miles. Temperature you have a choice.
Note: The water temperature graph can be set on or off (See page 11-4.). The temperature scale is fixed between 20-80 °F (0 to 30°C).
The battery is soldered and glued into the unit.The battery is a CR2450-3 volt lithium battery and apparently, easily found at radio shack for 7 bucks.
I realize this question is a little date, but in case anyone else has the same query I'll provide a link to the owner's manual. Replacing the battery/fuse information is on Section 12-2. The battery is a CR2450-F2 ST2.
If you reset it and while in the Initial Settings" Menu, you press menu, it should take you to the transducer setup screen. These menus allow for "Transducer Type" to be changed to your exact transducer. See the "Installation Manual", which is different than the "Operators Manual". Section 3 page 9 and 10. You may have to enter your units of measure (Knots vs MPH, etc), and then it will allow you to choose the transducer type. Hope this helps. John Barry, 847-746-0100, technicalmarine.com.
Yes and you have to get them from a Furuno dealer as they have to be purchased from Furuno. The cost is about $200. If I can be of assistance email me: [email protected]
pressing the "SNDR" button activates the sounder
press"ALARM" tyo acces alarm menu, turn them on or off there, look "NEXT PAGE" for alarm 2
847-746-0100
×