MY RICO MP 161 KEEPS ON SAYING LOAD THE TONNER EVEN AFTER REPLACIN. HOW DO I CLEAR THIS

Push the print button that keeps flashing and search for job reset. Cancel all. Hopefully that works!

Check in Drum Image Gear Kit. Maybe they are worn out.

Service mode is 'Clear-1-0-7-stop (hold stop until machine goes into service mode).

the LG chocolate is bad and knowen by battery problem and low capacity,, with your problem you must get new battery with best quality but I recommand you to change your mobile when you go back from Puerto Rico and have a good vacation.. ;)

Checks if the side door or the front door is closed

program it through web browser. type the ip address of the machine on browser and the mp2000le home page will come. click login on right hand corner and type admin as username and password should be blank. go to address book and type all email addresses there. its very easy mate.

First try entering into SP mode by pressing:
Clear button>1 0 7> and press and hold the Stop button for 3 secs. Then switch off and on the copier.
If SC 541 code is still there, check the following in the fuser unit:

• Fusing thermistors defective or out of position
• Thermostats open circuit
• Power supply board defective
• Loose connectors of Fuser unit.

Good luck and please rate me, thanks.

you can go to tech mode by doing this> clear(yellow) 1, 0, 7, then press and hold the clear/stop button (red) for 5 secs. the go to copier, mode, then memory clear all

possible toner pump

how to reset tonner