How do you use the reset button on a nordictrack e7 sv eliptical trainer

there would be a circuit barker on the treadmill. check whether it is in off position .
If you wish to get some details; visit the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

http://download.nautilus.com/supportdocs/AM_OM/Nautilus/NLS.E514.AM-OM.pdf

http://www.motorola.com/mdirect/manuals/T5XXX_User_Manual_E.pdf

listed under radios,but its elliptical,heres both manuals,you figure out

To initiate the calibration routine, hold down the SPEED +
button and the SPEED - button simultaneously for three seconds. During the calibration routine, the INCLINE
TRAINER will automatically rise to the highest incline level and then return to the lowest incline level.

P.S. This is listed in your user manual in the "Troubleshooting" section if you don't have a user manual then you can get a pdf copy of it here
http://www.ereplacementparts.com/images/nordictrack/CTK59020.pdf

www.alibaba.com/
Try this link to buy it online.
http://electronicshelponline.blogspot.com/

With regard to the clunking in the NordicTrack E7sv it turned out to be the left side wheel to crankshaft connection. It had come loose. I removed the left side foot rods and wheel cover plate for access. I re-seated the wheel on the shaft and tightened the hardware. Noise gone. So is all the squeaking associated with it loosening.

Sounds like it needs to be fixed. It will need a new left motor and cord most likely, less likely a lower board.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/russell_1d1c35fa8a5a0be4

Here is a link for the manual you need. Please rate me.

http://download.dfxi.com/supportdocs/OM/Schwinn/SCH_430_OM_RevA_web.pdf

Have the same problem with a Nordic Track Eliptical. Sorry, I have no solution. What solved yours?

If you are looking at right hand side of unit you have the flywheel next to it adjusting tension plate.If you have your manual handy it will show how to loosen this part so you may loop over the small idler pulley which goes around the much larger pulley wheel if not here is the web page to go to and its on page 21 Hope this nugget will help!
http://www.iconservice.com/CustomerService/manualsProductManuals.do?model=NTEL07808&version=0&company=11&modelName=NORDICTRACK+E7+SV+FRONT+DRIVE+ELLIPTICAL&language=

It's at https://www.dixiesales.com/ipl/935/84-0101%20English%20Manual%20-%2009-24-07.pdf