My washer doesnt twist black and force

Twisting together and electrical tape is not a safe fix with 110 volts and water around. You need crimp connectors and heat shrink sleeving.

You have to just force it out there are no tricks except use a pair of multi grips to twist it & hope it doesnt break.Usually if it does break it won't affect it anyway.good luck

There are to parts to the chuck. You hold the ring at the edge of the chuck from turning, and then you turn the part after that, ccw to release.

look on the bottom of the speedo, there is a cable there that runs to the fron wheel, check to make sure it is tight, if it is not, tighten it and it should work, if already tight, unscrew it and check the cable inside, pull it all the way out of its sleeve (the black plastic part) it will be very dirty, so be prepared. ensure both ends are square at the tips, if they are not you need a new speedo cable, if they are square on both ends, slide it back in all the way down and try to twist it, it should not twist once all the way in(but if you turn front wheel, it should twist inside sleeve). once the cable doesnt twist inside the sleeve, match the square end into the square hole where you unscrewed it from on the speedo, then tighten the sleeve nut back on tight. if this doesnt fix it, repost as "how do i relpace speedometer"

Remove rear cover of washer, and top cover also, tilt washer towards you, get someone to hold washer steady, fit belt round motor pulley,and slowly feed belt round drum pulley, watch your fingers, keep feeding belt round oulley, turning drum at same time, it will be tight, but persist, and belt will go on.
Please rate my solution.
Thanks.

The shift knob on a manual trans should twist off. Sometimes it takes a bunch of force. Are you replacing the knob? Then channel locks will work fine.

Its probably stripped out

Removed accumulated dust sticking on the board were the buttons touches.use cotton balls with alcohol or use clean damp cloth.If nothing's happen check the cord I'm sure it is twisted badly, open your ps2 use this controller and try to twist back the twisted cord if it stopped sometimes when your twisting it then you have to replaced the cord(make sure that your using the original ps2 controller not imitation)pls. rate

NOPE RUBBER WASHER JUST LINE UP THE GROOVES SIMPLE ....

open the top access panel, 3 screws in top rear.
start washer
push up gently on one of the center black wired connectors that connect to the control unit (in back top of washer)
if it starts to work then the relays on the control circuit board need to be re-soldered . a normal reoccurring issue
its rarely the latch