While copying the machine scans well, and print some few pages and stop with the following message :- Turn the main power switch (on the main unit's left side) OFF & ON, If the machine still does not operare normally, contact your service representative with the error code below. e000020
WB Teacher Eligibility Test 2021 results are expected to be released soon by the West Bengal Board of Primary Education (WBBPE). WBBPE has not yet released the precise date of the WB TET Exam 2021 Result. Candidates will be able to PSC Student wise Result 2021see or download the West Bengal Primary TET result whenever it becomes accessible on the official website.
Hi there
On the page below I can find an error code E002-0000 for your Canon model, but not the code you specify, as all codes seem to be in the xxxx-xxxx format.
The page is here and carries all the error codes
Error Codes Canon iR2520
Hope this is helpful, if so would you please register that with Fixya
Cheers
Testimonial: "Thank you all; I just realized it was a fan problems, I found the three fans FK2-0360-000 are not working, I am looking for the fans so I can replace them, I hope that is the cause of the problem, once I fix all the fans I will update the findings"
SOURCE: ERROR EOOOOOO-OOOO IN CANON6000 PRINTERS
Hi there
E000000-0000
E000 to E004 are all to do with the fixing unit.
It can be reset.
It has been known to be caused by noise on the mains supply so a filter might keep it away.
To reset. Press the star button followed by 2 and 8 at the same time, then the star button again.
You should now be in service mode.
Select COPIER and this will give you some options along the top.
Select FUNCTION.In the list select CLEAR.
From the next list select ERROR and press ok.
Then switch off machine and back on at the power socket.
If it clears then all is ok.
Be warned!! Do not try to change any settings in service mode or clear any other function!! It is very easy to turn the machine into a cabbage.
Sorry I cant help you more than this, hope it works for you
Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks
SOURCE: The copier is saying: Turn the
The shutter open sensor does not go on. (The shutter does not open.)
1. Check the shutter home position sensor. Is it normal?
2. Check the wiring between the finisher controller PCB and the stack
feeding motor and between the finisher controller PCB and the shutter
open/close clutch. Is it normal?
3. Is there a fault in the shutter mechanism?
4. Try replacing the stack edging motor and the shutter open/close clutch.
SOURCE: Error code E000007 - 0000 always appear on my Canon ImageRunner 3235 during copying and printing
The fuser film is not rotating properly.Replace it .
1,932 views
Usually answered in minutes!
×