I have a Amana washer that wont do ANYTHING but fill up. It has three cycles and it is the same on all cycles.

Sometimes this can happen when the power button does not return completely when pressed in. My cheap & cheerful solution was to use a bit of Blu-Tak on the button, so I could pull it all the way out.

Are you sure you have both hot and cold water connected? Try turning the water valve on, if you don't have hot water make sure you choose cold cycle. That's the first place I'd start.

Hi Kirby
First... Caution
Because your dealing with water & electricity it can be lethal to fiddle around inside. That said...
Washing machines are controlled by a master timer unit, usually mechanical, but rotated by an AC Clock motor. If the timer is not getting voltages to the various Switches around the "timer unit" or "clock motor" then the individual selected functions won't work.
Manually Rotating to a particular function then Activating the On/Off Push/Pull switch should start things happening even if timer motor is dead. So
If your OK with AC electrical goods then open it up.
Connection wires may have fallen off or something simple. A multimeter is your best friend here. Look for the big rotary clock behind the main control dial. Listen for the clock motor running. The main Push in & out Button is the On / Off switch. Check that its got AC on the input wire & switches across to the other wire when the knob is pushed in / out. This may be the problem...

You can always call an appliance repair technician!
Good Luck

Your agitator pindle. has come loose From the spline. Try to lift up on the agitator. If it lifts off the spindle easily then it has worn out the spline. That is what connects the agitator to the s

My washer will notwork it will not let the lid lock are fill with water

I spent some time wiggling the dial and it finally kicked in telling me I need a new switch

Bad timer. Replace it.

try putting it on spi - do you hear anything? could be a broken belt - very easy to fix.

tilt the machine backwards. with a multimeter, check continuity across the brushes - if open circuit then brushes need to be replaced

no, you need a lid switch. when the switch fails it wont do anything but fill. replace switch to fix problem