I have Philips remote control programed for Sanyo TV. I can not find where I set up sleep mode. Where do I find it?

How To Program A Philips Universal Remote ' Codes For ...

codesforuniversalremotes.com/program-philips-universal-remote/

Here is how to Program any Philips Universal Remote Control. Turn on the device you ... Remote Control Codes December 21, 2015 at 1:19 pm. Stephanie,

Codes For Universal Remotes ' Universal Remote Control ...

codesforuniversalremotes.com/

Universal Remote Control Codes For TV & Audio. ... Codes for Philips Universal Remotes · Sanyo TV Codes for Universal Remotes · Codes for .... I have an 19 inch Emerson flat screen and a RCA universal remote. Please help with the code ..

If so; what can we do? Contact Sanyo.

Hello

I don't have a code for Sansui TV to be programmed with Sanyo remote control But hava a philips Universal remote model which can be programmed for Sanyo TV and has its codes.

Remote Model ===> Philips CL 034 Universal Remote Controller.
Codes
0115 0632

And herealong with I sends some universal remote codes, that you can check it for.

Four Digit Universal remote code for Sansui TV are

0135 0310

Three digit universal remote code for Sansui TV are

135/ 136

Direct Code Entry

1. Press and hold the SETUP button until the red indicator stays on, then release the SETUP button.
2. Press and release the desired Mode button (TV, VCR, etc.). The red indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables. Note: after a valid code entry, the red indicator turns off. For an invalid code, the red indicator flashes.
4. With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your device, try one of the other codes for your brand.

Normally all sanyo kits have two remote acces codes. One is Press Sleep Button on the remote handet and Menu button on the front panel of the TV simoultaneously.
Second is a tricky one.
Press Volume+/Vol_ to set the volume level to zero and press 'REP' on the remote control hanset aln loosen.
Keep pressing Vol+/Vol_ on the unit and press 'REP' on the remote control again.
Factory status will be displayed.
This is the service mode. You can adjust the parameters with the help of programe and volume control buttons.
To exit from the service mode, do the above said three again, unless the chaged parameters will not be stored in memory.
Another method is, if the hanset has a hidden key, usually at the lower side, which seems as a small hole. press it with a small stick to fit, may enter to remote code options.

http://www.directv.com/learn/pdf/System_Manuals/Philips/Philips_DSX-5150_5353_5375.pdf
only one i found but they all seem to work the same.

no you require the remote or a universal remote or sometimes a cable remote that has been programmed to work the volume on the tv set will have an input button .

i need codes for ca sanyo tv

need the code for a sanyo tv 19 ince mode ds19330

check out Philips support website for codes and instructions for that individual remote. most of their codes are the same for most of their universal remote controls. I suggest getting the original replacement remote for your TV because then you can easily just put batteries in the remote and not have to worry about programming and loosing codes. get the original at www.replacementremotes.com and at the top of the site just type in your model number of you TV and click search. They will set you up with your original remote.