Dishwasher is flashing heavy but will not start the cycle

have a service technician in as it appears to be a problem in the program board
could be moisture across the circuit board

Sounds like a logic board problem. You may have to change the logic board!

The Start/Resume light is flashing

This flashing light indicates that your cycle or start-up was interrupted.
Possible causes: The door opened during the cycle, or the power was interrupted.
To resume operation: Make sure the door is closed, and press Start/Resume.

The Clean light is flashing

You should call for service if the Clean light is flashing and the machine is inoperable. It is normal if the Clean light stays on after the cycle is complete. The Clean light is an indication that the dishwasher has been run and that the dishes inside it are clean. Once the door is opened after the cycle is complete, the light will shut off.

The lights are rapidly flashing

Any key that gets stuck will rapidly flash. Press the key a few times in order to release it or press Cancel.

The Rinse Only light is rapidly flashing

If multiple keys are stuck, the Rinse Only light will flash. Press each key, one at a time, to release the stuck keys, or press cancel.

START/RESET status indicator light flashing

You have pressed the indicator light flashing START/RESET pad while the START/RESET dishwasher is running. This will cancel the cycle. The light will stop flashing after the dishwasher drains (about 90 seconds).

• Press the pad once to start the dishwasher. Press the pad a second time when the dishwasher is running only if you wish to cancel the cycle.

Power to the dishwasher was turned off while a cycle was running and power has just been restored to the dishwasher. The blinking lights indicate that the dishwasher is draining the potential water inside.

• The light will stop flashing after the dishwasher drains. A new cycle will start automatically.

Good luck

Most likely a control board or touched issue. Field service tech needed to be able to tell

Usually blinking lights are indicating bad touch panel buttons. Remove kick plate, (black panel under door) and find service instructions there. It will tell you how to test button panel, as well as any codes flashing. Also will tell you hot to try a reset.

It is in a delay wash mode.
Disconnect power for 60 seconds.
Re-connect power.
Press the Cancel button.
Press the regular wash cycle and start the dw.

you need to pull the dishwasher out and check your heating element.
to remove code hit heated dry and normal wash and toggle till all the lights light up and then hit cancel this should clear your code.
there is a problem with the heater or the heater curcuit
let me know how it goes

bad timer

1. To cancel the delay.press the delay pad again when the delay is counting down. The indicator light will go out and the cycle will start or resume immediately.
2. To cancel the delay and the cycle, press Start/cancel once to drain and turn-off the dishwasher.
3. Press Start/cancel twice to turn-off the dishwasher without draining.