Do you have a clutch motor or a servo motor? If a clutch motor check belt tightness. It could be slipping or too tight. If a servo motor, check the speed setting on the motor. There Is a knob to adjust the speed setting on the motor.
Want speed change motor pulley to larger size. larger belt from auto store.
There are several manuals available, depending on detail and complexity:
JUKI DDL 8700 Manuals
SOURCE: Hi I have 5 Juki DDL-8700-7 machines and I need to
So many machines you would be best at aution as one complete lot.
SOURCE: is there a simple way to slow the speed down on a
On the motor where the clutch is you will see thge large pin with a nut on it, as you press on the pedal the pin engages with the motor, if you loosen the nut and unscrew the pin bit by bit and try the machine you will get to a point where you will have absolute control on the speed.
SOURCE: I need to change the
hi there
how come tere doesn't seem to be a tray under the machine ? pleasemake sur your machine come with oil pan ( could be come with oil pan ). or maybe your are talked about other model.
please follwo this steeps to change oil for your machine if it come with oil pan:
1 - back head of machine to back said.
2 - you will found oil pan and in right said you can see screw for empty old oil please put any bottel under oil pan and remove that screw until oil is come down .
3 - try to clean oil pan with any dry material and rethight the screw again.
4 - but new oil on oil pan until arrive to high level and turn ON you machine any running it for arround 10 minutes to make oil goes throw all tubes insaid machine.
best regards
ashraf abozid
CAIRO -EGYPT
SOURCE: I just received my Juki
There should be a bobbin winding device next too and slighlty behind the drive belt.
Should be like this bobbin winder.
SOURCE: how solve Juki DDL 8700 automatic single needle
hi there,
1- check V belt if there's more loose plase make it tight littel.
2- check timming cam for thread trimmer , sometimes lock after trim and E7 appear.
please advice me type for control box ? i can give more help if you have basic knowledge for electronc. just email me if you want any time.
best regards
ashraf abozid
[email protected]
CAIRO - EGYPT
173 views
Usually answered in minutes!
×