How do I empty water from conditioner dispenser

You can either take the dispenser out , unclip top part of dispenser, then prise out the insert which has the holes fof the water, or if dispenser is in place ,with a small screwdriver, gently prise the fabric conditioner downwards and with an old toothbrush , remove the black mould

Fabric softener is dispensed by syphon. If the softener is not dispensing there might be a blockage in the water inlet. There is usually a twin solenoid the lets water I to the machine. One to the detergent and one to the conditioner. The water path is most likely blocked with water "debris". Try cleaning the tray and housing completely then have another go

fabric conditioner is dispensed during rinse cycle, if it does not work then either, try pouring hot water into dispenser, as conditioner tends to get goopie when dry, thus may have clogged up

If you can remove the dispenser from the machine try soaking it in HOT water. The fabric softeners can cause a wax like build up that can clog the dispenser. If the dispenser will not come out of the machine then pour Hot water into it, cycle the machine and repeat. It took a long time to clog and will take a while to remove the clog(several cycles). This will work but will take time. Mix water with your softener to keep it from cloging again, it will thin the softener and stop the build up. If you add 50/50 water/conditioner shake well and use twice the normal amount so you are getting the full amount of softener/conditioner into the washer. This will help i had a similar problem with my front loading washer.

Washing Machine has started to empty the Fabric Conditioner high water or blokage in draw
This video will show you how to keep your soap draw clear and how to service the parts
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.

This video will show you how to keep your soap draw clear and how to service the parts
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.

take out the drawer that the powder and conditioner goes in. the conditioner spout to allow the liquid to empty from the drawer will be blocked with a mixture of powder and conditioner. clear it thru with a sharp screwdriver or similar and wash under the tap. replace back in place should empty fine then. hope this helps.

have you tried cleaning the spray holes above the soap tray? if they get blocked up the water jets sideways and not into the conditioner tray. if it is blocked badly the header unit may need replacing. i dont think you have a water valve problem as you say some water is getting through.

Remove dispencer again, remove conditioner syphon assembly and clean up the little tube. Should then go okay