Can not didplay this video mode on kguard dvr

To reset a Kguard DVR system, you will need to locate the reset button on the device. This button is usually located on the back or bottom of the DVR, and is typically labeled "Reset" or "Factory Reset". Press and hold the reset button for 10-15 seconds, or until the device powers off and restarts. This will reset the DVR to its factory default settings.

panel problem

whatever the monitor is connected to is producing a signal that cannot be detected by the monitor. Check the settings on the device. If not post the device info.

By Default Kguard EL821 Password is 123456

but if you forget:- To obtain the factory default password, contact your retailer or directly send an email to KGUARD at [email protected]. CCTV Networking Technical Support https://fast.ulmart.ru/manuals/674188.pdf

Sounds like a DVR issue. Probably a defect. Check if there is a firmware update. It may cure that.

ihave atechwood dvr icat get no data and icant see any channels displayed ihave left it on all night like it said in book still cant see the please help

Don't waste your time, if possible take it back to your nearest Maplin with receipt and ask for a replacement or email ask for return item number and or request replacement or refund post back obtaining proof of posting.

this will get you through the front door Please try this temporary password 519070 to login this will let you get to the admin pass word page so that you can change it i found it on cctv.com page but it takes 7 trys to load the cctv page so im going to post it here for safe keeping

You should swtch your TV to the video mode on to the video output chosen for the device. Check the video connecion type by following the output cables from the DVR station or charging dock to to TV. it could be video 1, 2, 3 HDMI, Color stream HD1 , Color stream HD 2, by scrolling down on the video mode list you should get the picture on on of them with correct video mode. or like i was saying follow the output cable from dvr station to Tv to see which video mode it was connected.