Can't get rid of ventilate message on titanium plus machine

You need to push the hot water button on the machine panel to allow water to run out of the steam wand. After a few seconds the machines ventilate message should clear.

You need to push the hot water button on the machines panel to allow water to run out of the steam wand. After a few seconds the machines ventilate message should clear.

Try this run the hot water cycle for a few seconds, it that works, try steaming if you get the message again clear it by running the hot water cycle and then go to steaming, this time push in on the knob after you open it, it that works, then the tap rod or the valve assembly needs to be replaced.

The top right hand side can get hot if you have the cup warmer switched on.
I am finding that the steam boilers are starting to block up and the steam lines are getting scaled up.
If you have access to compressed air,undo the boiler and lines and blow them out.
I have had coffee jammed in the inlet of the flow meter,blowing through it will be a good test.
Good luck

I have a Gaggia Titanium and the steam valve is leaking can I get repair parts for it

Press the hot water button and allow water to flow from the steam arm until ventilate disappears and warming up appears on the display.
Ventilate after descale is normal.

the steam valve is most likly plugged with sacale or such have you decaled the machine latly may want to start there

Open hot water valve, for a few seconds, water will stream out and pump will engage to vent out water circuit.

Try this, when the message comes up press in on the steam knob, if that works and steam is released, then the tap rod on the steam valve has a problem, contact nearest dealer for new part or send it in for repair(ask for new style stainless steel valve).

Remove the milk frother,checked to see if it is blocked.
This can cause the machine not to ventilate correctly.
They tend to block with old hard milk.