At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Worked fine going down drain before. checked direct hose into floor drain and clear. after a few years now bucket starts filling even with direct drain to floor ?? how do i fix?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Assuming you have a hose connected to the bucket for drainage, it is necessary that the end of the hose be lower than the top level of the bucket or the bucket will fill before the hose drains. I see many people who have their units on the floor and run a hose up into a sink and wonder why the bucket fills. Gravity works.....if you cannot find a lower place to drain the water then you must raise the unit up on a table or stand of some sort to get the bucket higher than the drain.
I had the same problem....raised the unit 3 feet off floor, the drain hose is 4feet long...
But the secret to getting unit to drain into hose if unit is set to Continous is......
TILT the unit back about 5 degrees with a half inch piece of wood under front wheels and
She will drain into hose instead of bucket....
IF this don't work , I will eat the [email protected]
Based upon my experience with the same problem on my Kenmore 54701 last summer: The condensate water collects in a plastic pan below the coils. This pan has a single drain hole where the water flows down into the bucket. When I suddenly found water puddling on the floor instead of in the bucket, I opened up the unit, and I found that the collection pan's drain hole had become blocked by "bioslime". I cleaned out the goo from the drain hole, and the problem was solved.
Please try the following:
1) Remove the bucket.
2) You will notice a round outlet/spout where the water drips from into the bucket.
3) Remove the plug from the backside of the unit (you will now see a hole to the bucket area).
4) Feed a hose through the hole from the back and attach the end of the hose to the round outlet/spout.
5) Place the other end of the hose on a floor drain outlet.
6) Put the bucket back into the unit.
When the unit is turned on, the water will now flow through the hose instead (into the floor drain). When you want to use the bucket again to capture the water, you will need to remove the hose.
Check the float first - be sure the styrofoam on the bottom is still intact. Be sure that you can move it up and down freely (and easily) with the bucket out of the machine. If that is not bound up, and the foam is in place, next check the switch in the dehumidifier itself. It's directly behind where the float goes - the way to test it is to turn the dehumidifier on and push the metal tab in with your finger. The machine should cut out immediately - if it does not - the microswitch needs to be replaced. (they're very cheap, and simple to replace)
×