My movement sensor will not activate when veh is rocked, but the internal movement sensors work on entering,

You probably already tried this, but have you disconnected the battery, waited a few minutes, then reconnected? That might clear the memory and reset the brain (pcm).

There are settings on the sensor itself. Should be a dusk to dawn setting that will keep it off during those times and then function at night. as far as not working I would first suggest setting the sensitivity. Disrupting to power could have reset this.

I tried this and it worked fine
FACTORY RESTART:
A Factory Reset will erase the connection between the Display and the Thermo-hygro sensor and allow a fresh connection to be re-established. It is recommended to have the display and all sensors 5-10 feet apart for this restart.

ENTER PROGRAM MENU
Press and hold the SET button until you enter the program menu. Press and release the SET button until you see 'rES oFF' flashing.

FACTORY RESET ON
Use the UP ARROW key or DOWN ARROW key to turn rES on.

CONFIRM & COUNTDOWN
Press the SET key to confirm and a countdown timer will begin counting down from 127. When the timer displays dOnE, you must remove the batteries from the display for 10 minutes

REMOVE BATTERIES FROM THERMOHYGRO AND RAIN
While the batteries are out of the display, also remove the batteries from the Thermo-hygro sensor and the Rain sensor. Wait 15 minutes.

GENTLY KEY THE WIND SENSOR
Gently key the wind sensor one time to activate the sensor.

INSTALL BATTERIES INTO THERMOHYGO AND RAIN
Insert fresh alkaline batteries into the Thermohygro sensor and Rain sensor make sure to check polarity with the markings on the battery cover and inside the battery compartment. Wait 2 minutes.

INSTALL BATTERIES INTO DISPLAY: Insert fresh alkaline batteries into the Display. Make sure to check polarity with the markings inside the battery compartment
15 MINUTES: Wait 15 minutes for the outdoor weather data to display. If the outdoor data displays dashes after waiting for 15 minutes, repeat the steps of restart.
AZ Road Runner

what do you mean by reset?? are you talking about drive cycles not completing?? you tring to pass emissions? some veh will take up to 500 miles!! to go through all drive cyles ..or are you actually talking about a evap code I.E. p0440 and a cat codeI.E p0420??? if thats what your talking about those will need a repair to get those cleared

The sensor is defective

Hello,

I understand that it will work without the sensor bar. But, the reason why there is a sensor bar is that it needs to read the activity that is happening around it. It worked without the sensor bar while you did some exercises but it didn't when you bend over because the wii needs more sensory activity with that certain movement.

The functionality of the wii in detecting the movement is not full when the sensor bar is removed. I suggest you put in the sensor bar while doing all the exercises. If it doesn't work, just let me know by leaving a message in this thread.

Thanks,

Carlo

i think you mean "Air Filter". should be able to look in veh owners manual to see how to reset interior air filter sensor.

Hi:
I am pretty sure that fault code P0698 is for your throttle position sensor, or accelerator position sensor. Often, as this fails, you can clear the code, and it will come back on during throttle movement.

if it is getting hot something is slipping inside

faulty crankshaft position sensor is the most likely cause.