The Samsung DVD Remote quits controlling the player after the movie starts, yet the Samsung TV Remote will perform its basic play and pause functions. Seems to have something to do with the Wiselink connection with my Samsung DLP TV. After movie completes, the DVD locks up for a time; the DVD won't eject nor will the player power down.
Try to reset the blu ray player's remote control.
Remove the batteries and hold down the POWER button on it for 30 seconds.
Then replace the batteries with fresh ones
Can you please press the DVD button on the top of the Blu-Ray remote control then try to operate it whilst playing a DVD.
try both still won't work
×
The One For All 6-Device PVR Universal Remote Control
is preprogrammed at the factory to operate an RCA TV,
VCR, and satellite receiver, a Philips Tivo PVR, a Toshiba
DVD player, and a Pioneer audio receiver/amplifier.To
control devices other than the default brands,perform
the following steps; otherwise skip this section:
[*] Turn on a desired device (e.g.,VCR or
DVD player) and, if applicable, insert
media (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely
before proceeding.Highlight or write down the
codes and device you wish to program before
starting step 2.
[**] On the remote control,press a device key
once (i.e., TV,PVR,DVD, CBL/SAT,AUD,or VCR).
NOTE: To program control of a cable box or
satellite receiver, press CBL/SAT once.
NOTE: To program control of a CD player or
audio receiver, press AUD once.
NOTE: To program control of a TV/VCR Combo,
press VCR once.After programming, you will be
able to control channel selection, volume, and
VCR functions.
NOTE: To program control of a TV/DVD Player
Combo, press DVD once.After programming,
you will be able to control channel selection,
volume, and DVD functions
[***] Press and hold SET until the LED (red light)
blinks twice, then release SET.
[****] Use the Manufacturer's Codes of device and
brand name and then enter the first fourdigit
code for your device. If performed
correctly, the LED will blink twice.
NOTE: If the LED did not blink twice, repeat steps
2 through 4 and enter the same code again.
[*****]Aim the remote control at the device and
press POWER once.The device should turn
off. If it does not, repeat steps 2 through 5,
trying each code for your brand until you
find one that works.
NOTE: If the device does not have a POWER
key, press the (Play) key
[******]Repeat steps 1 through 5 for each device you want to control.
OK.
1,361 views
Usually answered in minutes!
×