How do i let my healthrider H75t trademill down

Let it run all the way up and down until it starts It is trying to calibrate itself It may take two cycles.

Guys ,
Try rewarding your body by feeding it isagenix

Warm regards
Isagenix Consultant
www.msranderson.isagenix.com
The Isagenix Wealth Creation solution
Cleanse for Life
The Isagenix Weight Loss Solution
The Official Site of Isagenix International

What brand is this?

Hi Larry,
What are you asking ?

More than likely your going to need a console...If you checked all the power from the console down to the resistance motor and that's good then console is bad.

could be bad incline sensor or c/board is going bad. one more try bipassing the board with power to the incline motor fully powered 18volt batt will or higher will move the motorby flipping thr wires on the bat the incline should go up and down. if working ok then check board

Could be several problems. You can isolate the motor and use a DC power source (power tool battery, Lantern battery)to check if the motor is good. If the motor is good then check to see if under the motor hood you have a "Tech Sheet" which should help you with the diagnosis. We use www.treadmillpartszone.com for parts.

The serial number decal should be in front bottom left hand side on the frame opposite the power cord. I would not worry too much about the serial number that is used for tracking their units. It sounds like the motor control board may have failed, but they may have you do a calibration to see if the board has actually failed.

OK two things, first is that you must check if the belt is in good condition and the deck also. second, we turn to the recommendation, review the motor controller if any diode or MOSFET is bad, and maybe check the main motor has to re-coiling

I have same issue. anyone know?