MY SCSI RAID HOST CONTROLER

clear massege

Visit the motherboard manufacturers website for the drivers you need. Even if you don't use the RAID function the hardware is still built on the motherboard and you will need the drivers for windows to communicate with the hardware correctly. You might also find the drivers on the "Driver" CD that came with the motherboard.

Cancel and disable in Device Manager. If not in BIOS.

ممك تعريف

first you need to prepare the scsi drives ie host raid adapter scsi drivers are server raid cotroller 6 scsi drivers by using the serevr raid support cd dikettitools proper os drivers to floppy and boot with widows cd at the time starting boot press f6 to specify the scsi drivers then all scsi hdd will detect for installatio.

Hello.

If you can see a yellow mark it means that the driver is not installed. Try to load you CD it will run automatically. If the same things happen you just right click the yellow mark then update the driver. Once the updating process you will wait for a minute it will require you to browse the location of the IDE. You need to browse your CD look for the IDE.

Thanks for using Fixya. Hope it will help you

ICmanServer

the drive needs the proper hardware installed,in manager on device ,right click the ? , then left click propertys , select update driver it will ask for permission to install , click yes,takes about 2 minits ( or) ,go to microsoft.com ,look for downloads,(type) drivers, your model, click search ,pick your drivers from list and download and install

Windows cannot find the correct drivers for this device. So, let's research a little bit.

Are you using SATA or RAID on the computer? If not, there is nothing that needs fixing.

If you are, then reinstall the RAID software from your motherboard installation disk, which should repair this issue.

If you do not have the driver installation disk from your motherboard, for whatever reason, go to their website. Almost every motherboard manufacturer provides easy access to drivers.

good luck
tony

You need to enter into scsi bios first, then do an autodetect for hard drive, this will set the IDE/SCSI hard drive on raid controller.

To enter SCSI control you need to press the same key stated on screen on startup (F6 I assume) I think F3 is just boot settings.

If the card do not enter regularly in CMOS settings for the raid then this card is defective.

That particular work station comes with both IDE and SCSI drive interface controllers. The IDE drive should be used for your OS. The SCSI drives for your data storage. Now, the issue is to get the SCSI to work in RAID_0 as I understand.

You iwll need a RAID controller such as Adaptec AHA-3940AU WD SCSI Host Controller, which may be found on eBay (used) for a very affordable price. The driver software may be downloaded directly from Adaptec, so I suggest you do that in the iterim peroid, and store drivers on a USB thumb drive.

Hope this helps you.