My 2007 Haundai Santa Fe rear passenger window wont go up how do I get it to go up

Call the dealer ask a mechanic how to open door they likely have a trick and they want you to buy the parts so ask for an exploded view of door and lock you might be able to fish the window and yank the lock bar

Motor malfunction, or the window regulator has broken inside the track.

should be under the dash most likely on the passenger side of vehicle or more to that side. you'll have to take a plastic cover off to get visual of blower motor.

Once you remove the door panel you can remove the switch from the panel

short in the drivers side door lock solenoid. replace it

The rear door problem is the lock actuator. The problem with locks keep activated when you close driver door. My uncle's Santa Fe has same problem and couldn't fix problem under any circumstances. I even rebuilt the entire lock system didn't help

run a wire from the battery to the switch,then to the motor to determine the fault.saves a lot of dismantling.

i had a problem not unlike this in my santa fe 1.9td uk spec.
my car had been sitting for a few months and when i returned to drive it again the same problem came to light.
i also rep[lsaced the key fob.
it could be one of two things.
firstly the systen might neen re-set. if you disconnect the battery for 2 hours then attach ti again it might work.
if this fails it might be the actuator in one of the doors. if it is faulty then it only semi closes the lock, but it then thinks that has to lock again. and locks the door.
hope this helps.
oscargilpin

most likely in the rear compartment on the side there should be a removable panel take it off to expose the jack

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door