Dishlex dishwasher. Performed the first time. Now its just making a vibration them switching off

Check if the heater is working. This can be done by checking if the dishwasher has steam and dishes are warm when cycle is complete. Also check if the Rinse aid has not finished. Make sure the Rinse aid dosage is not at too low.

Check whether the dishes are touching the door before closing the door..Or the spring mechanism of the latch is damaged

Have you selected the eco wash cycle.it wont dry on an eco cycle.

ok this sounds like your water has stopped coming in or timed out b4 the pressure switch is activated. hold eco button down, u will hear a beep then a light will come up, keep pushing the button until u see the light.reply and tell me which light has come up, and i can help u fix the problem.

Probably fatigued wiring from the chassis to the door where it bends every time you open and close the door. On my 500E, I took the sheet metal door skin off and found a couple of burned spots on the wires inside a clear plastic strain relief.

theres a round plug in the top of dish washer pull it out and clean could be cloged or the bottom spram arm can be pulled out and cleaned aswell

Thomo, make sure the sprayer holes in the spray arms are clean. Grains of rice seem to be a dishwashers biggest enemy as they don't desolve and eventually end up lodged in the spray holes. The holes at the end of the spray arms are the ones responsible for the washing out of the soap powder from the dispenser, if they are blocked this does not happen.
Hope this helps
Cheers

could be a multitude of issues causing water to leak, from misloading dishwasher to a faulty water valve. theres a pretty good trouble shooter/ tech sheet located on inside back wall behind the lower drawer

behind either the lower access panel or the behind the main door assy shlould be a tech sheet complete w/ trouble shooter and wire schematic