Go to midlandhardware.com.For about $4.00 more than just price ofthe motor,you get the complete saw 15amp.motor with a laser guide!The table saw has a 3yr. warranty,3 extension wings,and a sturdy stand.Shipping to your door $24.00,$198.58 total.
Http://www.ebay.com/itm/140614984387?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
I have a RM871 that I bought for my Craftsman Tablesaw. I installed it but because Sears builds some of their tablesaw housings out of plastic, it cracked beyond repair when it was used on a job. I trashed the tablesaw and kept the motor. It barely got used! Let me know if you are interested in buying it. Thanks. Doug
I have a RM871 that I bought for my Craftsman Tablesaw. I installed it but because Sears builds some of their tablesaw housings out of plastic, it cracked beyond repair when it was used on a job. I trashed the tablesaw and kept the motor. It barely got used! Let me know if you are interested in buying it. Thanks. Doug
I have a RM871 that I bought for my Craftsman Tablesaw. I installed it but because Sears builds some of their tablesaw housings out of plastic, it cracked beyond repair when it was used on a job. I trashed the tablesaw and kept the motor. It barely got used! Let me know if you are interested in buying it. Thanks. Doug[email protected]
I have a RM871 that I bought for my Craftsman Tablesaw. I installed it but because Sears builds some of their tablesaw housings out of plastic, it cracked beyond repair when it was used on a job. I trashed the tablesaw and kept the motor. It barely got used! Let me know if you are interested in buying it. Thanks. Doug
I have a RM871 that I bought for my Craftsman Tablesaw. I installed it but because Sears builds some of their tablesaw housings out of plastic, it cracked beyond repair when it was used on a job. I trashed the tablesaw and kept the motor. It barely got used! Let me know if you are interested in buying it. Thanks. Doug
SOURCE: I have a Craftsman table saw with a burned out
SOUNDS LIKE THE PROBLEM I HAD, BUT WAS JUST A SEIZED-UP BEARING. I WENT TO LOCAL ELECTRIC MOTOR REPAIR ($15.74) PARTS AND LABOR, THEY REPLACED THE BEARING, THERE ARE 2 BEARINGS ON IT, COST IS THE SAME FOR EACH. THE BEARING IS PRESSED ON, SO REPLACEABLE. HOPE THIS HELPED
SOURCE: New or used motor for a Craftsman 10" table saw
You can try Sears but they can be a bit pricey. I use to send out motors for a factory I worked in to a rebuilder who would even do new windings. Check in your area for a rebuilder, As for the replacement being a Sears unit they may have a similar motor in stock. Good luck.
SOURCE: New or used motor for a Craftsman 10" table saw
Sears no longer sells repair parts for this motor, only the whole motor as a replacement part, and it is $140.00, but you can buy replacement bearings from drillspot.com the bearing needed is an Enduro 6200 zz c3
SOURCE: i need a table saw motor model rm871 where can i
I need the rear bearing for this motor, Where can I find one? Mine blew up. RM871 sears.
3,187 views
Usually answered in minutes!
×