How to fix haier washing machine inlet valve dripping

Hi, if you turn off water to machine, remove flexable feed pipe to it and look into inlet hole, you should see a filter, this should pull out, maybe with plyers carefully, if blocked, clean with bleach, or descaler, ours (on a bosh machine, is in the actual tap on the wall, most odd that.) & replace.
If this is the cause, I would do it maybe every 6 months or yearly, depends on age of machine.
Hope this helps.

I would replace the pump impeller first!

The drip would be coming from the water inlet valve that is mounted under the console.

You can replace it. First disconnect the mains chord from plug and close the water inlet taps on the wall. Open the screws holding the console and turn it back. Make sure you don't drop it.
This will expose the water inlet valve. Check none of the hose clamps have come off or loose. If that is the case then tighten or fix the clamps. Otherwise you will have to replace the valve.

It is available from this online shop. See item 15 in the diagram.
ADMIRAL Washer Controls and water inlet Parts Model ATW4676BQ0

THE WATER INLET FILTER IS MISSING , SO IT ALLOWS SOME FRAGMENTOF DIRTS INTO THE SYSTEM......U HAVE 2 LOSSE WATER INLET VALVE AND CLEAN

NO the inlet valve is damaged replace the inlet valve hope this works

Water-inlet valves eventually fail. One problem that may develop with a water-inlet valve is that it can no longer completely shut off when the electricity is turned off to it. Then, the valve may leak and drip water into the clothes tub--you may notice that your washer has water in it when you haven't used it for a few days. To fix this, replace the valve. Here is the part you need for your machine.
Happy Holidays

turn hot water tap off if it still drips replace cold water inlet valve if it stops replace hot water valve