I bought a cordless lawnmower at auction but unsure how to get it to work

To remove the positioning lever from a Bosch Rotak 34-13 lawnmower, follow these steps:

1. First, disconnect the lawnmower from the power supply to ensure safety.
2. Locate the positioning lever on the handle of the lawnmower.
3. You may need to remove the screws or bolts that are holding the positioning lever in place. Use a screwdriver or wrench as required.
4. Once the screws or bolts have been removed, gently pull the positioning lever out of its slot.
5. If the positioning lever is still stuck, you can use a flat-head screwdriver to gently pry it loose.
6. Once the old positioning lever has been removed, clean the area thoroughly and remove any debris or dirt that may be present.
7. Now you can install the new positioning lever by sliding it into the slot and securing it in place with screws or bolts.
8. Finally, reconnect the lawnmower to the power supply and test the positioning lever to ensure it is working properly.

If you are unsure about any of the steps or do not have the proper tools, it is recommended to consult a professional for assistance.

no where
it is an auction and if you didn't test it first , then that is your problem
auctions are where people sell junk or companies sell repossessed junk

There are so many different model for Ryobi cordless lawnmower, would you please tell which one you need?

it is most likely the thermocouple needs replacement

http://www.cart32hosting.com/estore/template/thumbnails.php?id=010780&cid=39

Contact Celestron:

http://www.celestron.com/c3/home.php

I assume you mean convert it to corded, connected to the mains; cordless is electric as well.
It is possible but there are conversion losses as compared to using a 'native' AC corded mower motor.
It also depends on why you want to convert it. If you find the battery unit underpowered, adding a 12v power supply and cord will not solve that, it will just extend the run-time to continuous, assuming the motor does not overheat, as it is probably designed to match the battery run length for on/off cycle times.
You could consider trading, or selling yours and buying a corded mower.

battery is toast...sorry:o(

Hey Graham:

Here is an owner's manual for your lawnmower.

sysdoc.doors.ch/HONDA/31VA5030.PDF

Enjoy!

Steve

You can find parts information and exploded views for your mower here. You'll need to pick the series mower you have from the list. The service site's home page is here. At the bottom of the center pane is box where you can enter your model number to find the manual. With the views they give, you should be able to get the mower apart to replace the batteries yourself. Good luck on the project!

Take a look at this web site. Just click the link:
http://www.logitech.com/index.cfm/mice_pointers/mice/devices/3295&cl=us,en

Your battery may be dead.
Software for your mouse listed at this link:
http://www.logitech.com/index.cfm/support_downloads/downloads/&cl=us,en?selectedcrid=398&selectedcid=146

I do not have your v220 mouse so I'm unsure if you can replace it with a standard battery. Check it or exchange it from where you bought it.
Good Luck & kind Regards.
& please vote.