Ipad has voice over only when turned on..blank screen

Hi Tracy..., last month my ipad got black screen also, all i have to do is.. I open it
slowly and carefully pull-up the touch screen,then i remove the LCD and at the back of LCD you can see the black plastic cover, carefully remove it,then when finish removing it, at left side there is flix ...that is the connection of backlights...
if you see that is broken that causes you the ipad turn black screen, all you need is to get a soldering iron and a lead then fix that 9 connections of flix one by one ..and after that, all parts that you remove return it carefully and restart your ipad..and you have your ipad now back to normal

To reset your iPad, just press the on / off switch (on top of the iPad) and the home button (in the centre on the bottom) simultaneous and wait till the screen goes blank and the apple loge appears. Then you can release both buttons. Wait till the apple logo is gone and 10 seconds later you can switch on the iPad with the on / off button.
That should be enough.

If this does not work like you expect, see what Apple has to say to do a "deeper" (Factory) reset. Be aware you will lose all data. When you do connect the iPad to your computer regularly and you have a backup in iTunes, this is great, because you then can restore everything like it was last time you connected to the computer. Turn your iOS device off and on restart and reset

Try removing the battery for 30 seconds.

You could try to reset the iPad. Press the home button and the on / off button together and hold them till the light goes out.about 5 seconds. Then the apple logo comes back and in within one minute the starts screen should reappear.
I hope it works, because I would hate it if your grandson had to turn over his piggy bank. (Joking)

It also may make you reset the iPad. Not sure why it does that after getting any update.

Settings > General > Accessibility > Voice Over > Off

This is in the Vision section and is intended to assist the visually impaired.

It is quite possible that you will need the LCD replaced as it might have become damaged in the fall.. To see, reset the iPad by pressing and holding the home button and the power button at the same time, when the screen flickers and turns off release the home button only. If the iPad turns on but still has white screen, you most likely will have to have it replaced...

I think You have voice over feature turned on.
Open settings, than open general, than open accessibility than turn off Voice over.

Try reseting the iPad by holding the home and power buttons simultaneously until the iPad completely shuts down and the Apple logo appears.


Once the Apple logo appears you can release the buttons. If this does not work, you may need to connect your iPad to your computer and do a factory restore using iTunes.

I belive you can hold down the home button and the lock button and keep holding them down but you can always connect it to Itunes on your computer.