How do I reset the software? My X7i keeps rebooting every 2 minutes and we are no longer able to use the machine

Did you ever get an answer , I too am having the same problem. If you did receive any help can you email me.
[email protected]
I have tried everything .

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience.
http://electronicshelponline.blogspot.com/
http://electro-medical.blogspot.com/

I called Swingline and they told me to unplug the machine for 45 minutes to an hour, and then try again. (This resets the machine supposedly.) If there are additional problems, I was told, you may have to look into warranties, etc.

Reset the machine with the small button to the side of the power button, and disconnect the machine power cord by 2 minute and toucht the small swithc with the eraser pencil make click.
Now try again. However if the problem persist try this:
Unplug the treadmill. Locate the console key and place the safety or reset key into the treadmill console. Replace any parts that need replacing, or is large enough to trigger with a pencil eraser or Q-tip. Plug the treadmill plug back into the wall. Use the Q-tip to press the reset button. It may be necessary to hold the reset button down for a few seconds. "CL11" will appear in the display of the treadmill.

• 3

Press the reset button one more time with the Q-tip. "CL21" should appear on the screen. Press the enter key. The display will change again and show "CL22." Keep pressing the enter key until the numbers cycle through to the number "CL26." Press enter one more time. The letter E should appear on the display screen.

• 4

Press enter twice more. The letters "SS" should appear on the screen. When this happens, press the start/stop key. Making sure to keep well away from the tread, press enter to start the treadmill. The treadmill will start on its own. The treadmill will stop on its own after a few seconds. When it stops, press the power key two times. Remove the safety key and put in a safe place. Your treadmill is reset.move on to the next step.

• 2

Locate the reset switch on the underside of the treadmill console. Usually the button

God bless you

please see the video and fix it. God bless you

Wow, lots of scary posts. If I had read this before, I would never have bought it. :)

Anyways, there is a solution. I dont think this post was ever resolved, so I ran across this site that offered a few steps that allowed me to fix the reboot issue and a few nice folks who would reply to any questions.

This sounds like a common problem with ifit on treadmills. I came across this site a few weeks back and it helped! There's a few folks there that could offer suggestions too. best of luck!

https://thatguyreviews.com/treadmill-display-rebooting-ifit/

Hope this helps!

go to the web site they a LOT of tool +software update for you ifit
http://support.ifit.com/home

God bless you

try to RUN the software calibration, see your instr. manual how to enter and proceed for easy diagnose, troubleshooting, and fix it.
God bless you

yes the console software is damaged, but I have not heard of a card to repair this. they ususally send the console.