How can I get a drip tray for rwc100? - Ragalta Countertop Water Cooler rwc100 -

To reset your Jura S8 coffee machine and remove the stuck drip tray, you can try the following steps:

1. Unplug the coffee machine and wait a few minutes for the internal components to cool down.
2. Gently try to wiggle the drip tray to see if you can loosen it from its stuck position. Be careful not to force it, as this could damage the coffee machine.
3. If the drip tray is still stuck, you can try resetting the coffee machine. To reset the machine, you will need to locate the reset button or switch. This may be located behind the water tank, under the machine, or in the control panel. Consult the owner's manual for the exact location of the reset button.
4. Once you have located the reset button, press and hold it for a few seconds until the machine resets. This may cause the drip tray to release and be able to be removed.

Here is the replacement tray

Jura J9.2-J9.3-J9.4-J90-J95 Drip Tray - Espresso-parts.com

https://www.espresso-parts.com > Jura-J9-2-J9-3-J9-4-J...

The J9.2-J9.3-J9.4-J90-J95 Drip Tray catches excess water/coffee while the machine is operating. When the Drip Tray fills to its max capacity, ...
US$89.97 · ‎In stock

1. Consult the owner's manual for the location of the drip tray.
2. Gently attempt to remove the piece under the doors to see if the drip tray is located there.
3. Some Samsung refrigerator drip trays are accessible only from the rear.
4. Reply with the model number for more assistance.

If you cannot insert the drip tray as you have said above then the machine needs for you to find a way to insert the tray then the message should go. If the tray has an extra bucket on it for spent grounds then try removing that and just fitting the tray alone.

Coffee or clear hot water?

Why don't you replace the tray or repair the one that is there? 12579803 Drip Tray
12579803 Drip Tray
12579803 Drip Tray
Last is best priced, Sea Breeze

User Manual and Parts Manual

Miele CVA 4066 -Empty drip tray warning would not go off even after draining the drip tray, cleaning contacts, and resetting power. Water was coming out from under the empty tray.
I pulled unit out and removed sheet metal in rear around water inlet. when I attached water line and power cord & turned on power, I could see water dripping out of one of the 2 solonoids on the water inlet valve. $168.00 from Miele and no expensive service call.

Hi
Lift up on the front of the drip tray and pull out the front. There are 2 locking pins on the bottom of the drip tray that lock into the machine, that is why you lift up on the front of the drip tray before you pull out.

IF you are talking about the 4" mid bass it is roughly this. Frequency Response: 59 - 7,000Hz. You should use an electronic crossover set at 118-150 hz to be safe. :D

do not frustrated .firsly you should look for any THING THAT block the drip tray from geting out. usually it can be pulled out by PUSH ASIDE THE DRIP HOST SOMTIMES BLOCKING THE DRIP TRAY MOVEMENT IN OR OUT.
LATER CLEANED THE DRIP TRAY & REINSERT IT BACK TO ORIGINAL SITE